dt-bindings: Add TMP512/513 documentation
Add documentation for TMP512/513 sensor chips
Signed-off-by: Eric Tremblay <etremb...@distech-controls.com>
---
.../devicetree/bindings/hwmon/tmp513.txt | 32 +++++++++++++++++++
1 file changed, 32 insertions(+)
create mode 100644 Documentation/devicetree/bindings/hwmon/tmp513.txt
diff --git a/Documentation/devicetree/bindings/hwmon/tmp513.txt
b/Documentation/devicetree/bindings/hwmon/tmp513.txt
new file mode 100644
index 000000000000..dbfade74f6b1
--- /dev/null
+++ b/Documentation/devicetree/bindings/hwmon/tmp513.txt
@@ -0,0 +1,32 @@
+TMP513 system monitor sensor
+-------------------------
+
+Require node properties:
+- compatible: one of
+ "ti,tmp512"
+ "ti,tmp513"
+- reg : the I2C address of the device. This is 0x5c, 0x5d, 0x5e, or 0x5f.
+
+Optional properties:
+- shunt-resistor-uohm : The shunt resistor value in uOhm. If 0, the
calibration process
+ will be skiped and the current and power measurement engine
will not work.
+ Temperature and voltage measurement will continue to work. The
shunt value also
+ need to respect : rshunt <= pga-gain * 40 * 1000 * 1000. If
not, it's not possible
+ to compute a valid calibration value. Default to 1000 uOhm.
+- pga-gain: The gain value for the PGA function. This is 8, 4, 2 or 1. Default
to 8.
+ The PGA gain affect the shunt voltage range.
+ The range will be equal to: pga-gain * 40mV.
+- bus-voltage-range: 32V or 16V, default to 32V.
+- nfactor: u8 array of three(TMP513) or two(TMP512) n-Factor value for each
remote
+ temperature channel. Default to 0.
+ See datasheet Table 11 for n-Factor range list and value
interpretation.
+
+Example:
+ tmp513@5c {
+ compatible = "ti,tmp513";
+ reg = <0x5C>;
+ shunt-resistor-uohm = <330000>;
+ bus-voltage-range = <32>;
+ pga-gain = <8>;
+ nfactor = [01 F3 00];
+ };
--
2.17.1
