Erez Doron wrote:
>
> HI
>
> I'm using the 'rsh' command to execute command on a remote computer:
> when i issue:
> local> rsh remote echo hello
>
> it waits for a lot of time and tells me:
> poll: protocol failure in circuit setup
>
> but if i do only 'rsh remote' and then ' echo hello' it works !
>
> any idea ?
>
> thanks
> erez.
I had just the same problem, but I cant remember how it was finally solved...
;-)
Can you post the NIC cards models, kernel version (and special related drivers
used) special networking HW on the way between the two machines, etc' etc'
relevant information ?
Boaz.
--
/"\
\ / ASCII Ribbon Campaign
x Against HTML Mail
/ \
=================================================================
To unsubscribe, send mail to [EMAIL PROTECTED] with
the word "unsubscribe" in the message body, e.g., run the command
echo unsubscribe | mail [EMAIL PROTECTED]