Hello, I've installed Mandrake10.0 on a computer in my lab (the computer has two network cards. At the network configuration stage I've filled in all the required parameters: IP (static), DNS, gateway, hostname. The eth0 interface started with no error message, but the network is not accessible. I can ping myself, but pinging anything else (including the gateway and the dns servers) fails with Host unreachable error (using both IP and hostname). Before installing mdk10.0, there was redhat linux installed on this computer and the network worked fine. There are two identical onboard network cards (Intel) network cards, but the first one is recognized as Gigabit one.
ifconfig does not say "RUNNING": [bgbg]$ sudo /sbin/ifconfig eth0 Link encap:Ethernet HWaddr XX:XX:XX:XX:XX:X inet addr:XXX.XX.XXX.248 Bcast:XXX.XXX.XXX.255 Mask:255.255.255.0 inet6 addr: XXXX::XXX:XXXX:XXXX:XXXX/XX Scope:Link UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 Mb) TX bytes:0 (0.0 b) Base address:0x8000 Memory: e0300000-e0320000 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host RX packets:845 errors:0 dropped:0 overruns:0 frame:0 TX packets:845 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:64422 (62.9 Kb) TX bytes:64422 (62.9 Kb) Any ideas? -- Boris Gorelik Thu, 05/Aug/2004, 18 Av 5764 ================================================================= To unsubscribe, send mail to [EMAIL PROTECTED] with the word "unsubscribe" in the message body, e.g., run the command echo unsubscribe | mail [EMAIL PROTECTED]
