I have done an installation on Compaq Proliant 1200, Redhat 6.0 did pick
up the cards quite smoothly, I cannot recollect correctly, but I think I
had a similar problem trying to install RH 5.2.
I'm sure RH 6.0 shouldn't be a problem.
-Rupesh
On Fri, 17 Dec 1999, K K Pareek wrote:
> We are using RHL 6.0 on our Proliant 5000 for quite some time. The network
> card is on board same as yours. The installation detects it too. Why do not
> you try RHL 6.0 instead of RHL 5.2.
>
> K K Pareek, J K Cement Works, PO- NIMBAHERA, Raj-312617
> E-mail: [EMAIL PROTECTED]
>
> >Am installing Red Hat 5.2 (Old is Gold !!) on a Compaq Proliant 1600
> > machine. But it is unable to probe any network card that comes listed
> > with it while installation.
> >
> > Compaq site too is of little help. I can't even figure out what Network
> > card they use:
> > This is what they say: Compaq Netelligent 10/100 TX UTP Controller on
> > the PCI local bus
> >
> > Does anybody have any experience to enlighten us!!!!
> >
> > Warm regards,
> > Kimi
>
>
>
> --------------------------------------------------------------------
> The Linux India Mailing List Archives are now available. Please search
> the archive at http://lists.linux-india.org/ before posting your question
> to avoid repetition and save bandwidth.
>
--------------------------------------------------------------------
The Linux India Mailing List Archives are now available. Please search
the archive at http://lists.linux-india.org/ before posting your question
to avoid repetition and save bandwidth.
