From: Olliver Schinagl <oli...@schinagl.nl>
In the gpio bindings documents it is requested to use the marco's in
include/dt-bindings/gpio/gpio.h whenever possible. The gpios in the led
drivers don't seem to form an exception, so update the example in the
document bindings.
Signed-off-by: Olliver Schinagl <oli...@schinagl.nl>
---
Documentation/devicetree/bindings/leds/leds-gpio.txt | 12 +++++++-----
1 file changed, 7 insertions(+), 5 deletions(-)
diff --git a/Documentation/devicetree/bindings/leds/leds-gpio.txt
b/Documentation/devicetree/bindings/leds/leds-gpio.txt
index f77148f..d544cf1 100644
--- a/Documentation/devicetree/bindings/leds/leds-gpio.txt
+++ b/Documentation/devicetree/bindings/leds/leds-gpio.txt
@@ -26,16 +26,18 @@ LED sub-node properties:
Examples:
+#include <dt-bindings/gpio/gpio.h>
+
leds {
compatible = "gpio-leds";
hdd {
label = "IDE Activity";
- gpios = <&mcu_pio 0 1>; /* Active low */
+ gpios = <&mcu_pio 0 GPIO_ACTIVE_LOW>;
linux,default-trigger = "ide-disk";
};
fault {
- gpios = <&mcu_pio 1 0>;
+ gpios = <&mcu_pio 1 GPIO_ACTIVE_HIGH>;
/* Keep LED on if BIOS detected hardware fault */
default-state = "keep";
};
@@ -44,11 +46,11 @@ leds {
run-control {
compatible = "gpio-leds";
red {
- gpios = <&mpc8572 6 0>;
+ gpios = <&mpc8572 6 GPIO_ACTIVE_HIHG>;
default-state = "off";
};
green {
- gpios = <&mpc8572 7 0>;
+ gpios = <&mpc8572 7 GPIO_ACTIVE_HIGH>;
default-state = "on";
};
};
@@ -57,7 +59,7 @@ leds {
compatible = "gpio-leds";
charger-led {
- gpios = <&gpio1 2 0>;
+ gpios = <&gpio1 2 GPIO_ACTIVE_HIGH>;
linux,default-trigger = "max8903-charger-charging";
retain-state-suspended;
};
--
2.1.4
--
To unsubscribe from this list: send the line "unsubscribe linux-input" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
