"Bj\xrn Mork" <[EMAIL PROTECTED]> writes:
> Stefan R�llin <[EMAIL PROTECTED]> writes:
>
> > With FIR I have no luck at all. When I try 'modprobe nsc_fir' (after 'rmmod
> > serial') I get the error
> >
> > /lib/modules/2.2.14/misc/nsc_fir.o: init_module: Device or resource busy
> >
> > There is no message appearing in /var/log/messages
> >
> > When I disable the infrared port in the bios the same error as above occurs,
> > but at least I get the following kernel message:
> >
> > Jan 6 20:39:11 laepi kernel: nsc_fir, Found NSC PC97338 chip, revision=3
> >
> > Any hints?
>
> I had a similar problem with smc-ircc until I remembered to remove this
> line from /etc/modules.conf:
> options irport io=0x02f8 irq=3
>
> But since you use irattach instead of irport, I guess you haven't set
> any options for irport.
The NSC driver does not use irport, since it implements this stuff (much
better) itself. It has a mode called extended IR mode where SIR which is
much better than the normal UART 16550 stuff.
-- Dag
--
/ Dag Brattli | The Linux-IrDA Project /
// University of Tromsoe, Norway | Infrared communication for Linux //
/// http://www.cs.uit.no/~dagb | http://www.cs.uit.no/linux-irda/ ///
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www4.pasta.cs.UiT.No/mailman/listinfo/linux-irda
