On Wed, Apr 05, 2000 at 11:43:57AM +0200, Johan Gr�nvall wrote:
> I changed the IR port to ttyS3, IRQ 11, 2E8 and now it works fine!
While trying to get my own infared to work I have a question.
Why did you set the IR port to values which conflict with findchip?
What are the setting in your bios for IR?
Are the values above the ones which are reflected in your bios?
What method did you use to figure out IR was on ttyS3?
> Does any one knows if there is module support for this chipset? (want to
> run FIR)
>
> findchip -v
> Found SMC FDC37N869 Controller at 0x3f0, DevID=0x00, Rev. 0
> SIR Base 0x2f8, FIR Base 0x0
> IRQ = 3, DMA = 0
> Enabled: yes, Suspended: no
> UART compatible: yes
> Half duplex delay = 0 us
Thanks in advance,
Shane Owenby
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www4.pasta.cs.UiT.No/mailman/listinfo/linux-irda
