On Tue, 9 May 2000 11:53:13 +0200, you wrote:
> Hi,
> some curious messages in the syslog with vanilla 2.2.15
>
> IrDA (tm) Protocols for Linux-2.2 (Dag Brattli)
> nsc-ircc, Found chip at base=0x02e
> nsc-ircc, driver loaded (Dag Brattli)
> IrDA: Registered device irda0
> nsc-ircc, Found dongle: Sharp RY5HD01
> nsc_ircc_init_dongle_interface(), Sharp RY5HD01 not supported yet
> irlap_change_speed(), setting speed to 9600
> nsc_ircc_change_dongle_speed(), Sharp RY5HD01 not supported yet
> nsc_ircc_change_dongle_speed(), Sharp RY5HD01 not defined by irda yet
>
> Although it works ...
The problem is that laptops doesn't support probing for transceivers, so you must
set this manually:
options nsc-ircc dongle_id=0x09
alias irda0 nsc-ircc
... it will still work for SIR mode, but for FIR mode you'll need these changes
to your /etc/conf.modules
Have you tried it at FIR speeds?
-- Dag
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www4.pasta.cs.UiT.No/mailman/listinfo/linux-irda
