Hi Sergey
I have a Gateway Solo 9300 too. Have you changed the FIR setting in the BIOS
to IrDA?
This is in BIOS>Advanced>IO Device Configuration>IR Port>Mode>IrDA
It was already set to IrDA on mine but your file below looks as if you have
FIR enabled instead
regards
Gary
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Sergey V. Udaltsov
Sent: Wednesday, October 18, 2000 2:21 PM
To: [EMAIL PROTECTED]
Subject: [Linux-IrDA]How to enable IR interface
On my Gateway Solo 9300, there is NSC IR interface, disabled by vendor.
How can I enable and use it with Linux-Irda tools?
%findchip -v
Found NSC PC7338, Controller at 0x398, DevID=0x0b, Rev. 2
SIR Base 0x0, FIR Base 0x0
IRQ = 0, DMA = -1
Enabled: no, Suspended: no
UART compatible: yes
Half duplex delay = 0 us
Thanks for any ideas...
Sergey Udaltsov
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www.pasta.cs.UiT.No/mailman/listinfo/linux-irda
_______________________________________________
Linux-IrDA mailing list - [EMAIL PROTECTED]
http://www.pasta.cs.UiT.No/mailman/listinfo/linux-irda
