On Thu, Nov 05, 2015 at 09:34:44PM +0800, Chen Feng wrote:

> +Required properties:
> +- compatible: Must be "hisilicon,hi655x-regulator-pmic";

If this is a subfunction of a MFD it shouldn't have a compatible string.
If it is instead a standalone device it should just have a name in the
form "vendor,chip" without any random suffixes.

> +- regulator-name: Regulator name in SoC.
> +- regulator-min-microvolt: Smallest voltage support.
> +- regulator-max-microvolt: Largest voltages support.

These should *never* be mandatory properties and the generic regulator
bindings should be reference rather than copied into the binding for a
specific device, that way the standard definitions for things are always
used and people know about any other properties that are available as
standard.

> +- regulator-off-on-delay: The time wait for power steady
> +- regulator-ctrl-regs: Registers offset of control register.
> +  In turn with enable disable and status register offset.
> +- regulator-ctrl-mask: The control mask of the register.
> +- regulator-vset-regs: Voltage set register offset.
> +- regulator-vset-mask: voltage set control mask.
> +- regulator-n-vol: The num of support voltages.
> +- regulator-vset-table: The table of support voltages.

Why is this in the binding?  This is a binding for a specific device,
there is no point in putting all these data tables in the DT - it just
bloats the DT and makes it harder for us to enhance our support for this
device in the future.  Just 

> +
> +Example:
> +        pmic: pmic@f8000000 {
> +                compatible = "hisilicon,hi655x-pmic-driver";
> +             ...
> +                ldo2: regulator@a21 {
> +                        compatible = "hisilicon,hi655x-regulator-pmic";
> +                        regulator-name = "ldo2";
> +                        regulator-min-microvolt = <2500000>;
> +                        regulator-max-microvolt = <3200000>;
> +                        regulator-valid-modes-mask = <0x02>;
> +                        regulator-initial-mode = <0x02>;
> +                        regulator-off-on-delay = <120>;
> +                        regulator-ctrl-regs = <0x029 0x02a 0x02b>;
> +                        regulator-ctrl-mask = <0x1>;
> +                        regulator-vset-regs = <0x072>;
> +                        regulator-vset-mask = <0x3>;
> +                        regulator-n-vol = <8>;
> +                        regulator-vset-table  = <2500000>,<2600000>,
> +                                                <2700000>,<2800000>,
> +                                                <2900000>,<3000000>,
> +                                                <3100000>,<3200000>;
> +                };
> +             ...
> +     }
> -- 
> 1.9.1
> 
> 

Attachment: signature.asc
Description: PGP signature

Reply via email to