[PATCH 13/14] ARM: dts: sun8i: enable mmc for H8Homlet Board.

[Vishnu Patekar]

This enables mmc0.

Signed-off-by: Vishnu Patekar <vishnupatekar0...@gmail.com>
Tested-by: LABBE Corentin <clabbe.montj...@gmail.com>
---
 .../boot/dts/sun8i-a83t-allwinner-h8homlet-v2.dts    | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-a83t-allwinner-h8homlet-v2.dts 
b/arch/arm/boot/dts/sun8i-a83t-allwinner-h8homlet-v2.dts
index 342e1d3..6c1f598 100644
--- a/arch/arm/boot/dts/sun8i-a83t-allwinner-h8homlet-v2.dts
+++ b/arch/arm/boot/dts/sun8i-a83t-allwinner-h8homlet-v2.dts
@@ -43,6 +43,7 @@
 
 /dts-v1/;
 #include "sun8i-a83t.dtsi"
+#include "sunxi-common-regulators.dtsi"
 
 / {
        model = "Allwinner A83T H8Homlet Proto Dev Board v2.0";
@@ -57,6 +58,25 @@
        };
 };
 
+&pio {
+       mmc0_cd_pin_h8homlet: mmc0_cd_pin@0 {
+               allwinner,pins = "PF6";
+               allwinner,function = "gpio_in";
+               allwinner,drive = <SUN4I_PINCTRL_10_MA>;
+               allwinner,pull = <SUN4I_PINCTRL_PULL_UP>;
+       };
+};
+
+&mmc0 {
+       pinctrl-names = "default";
+       pinctrl-0 = <&mmc0_pins_a>, <&mmc0_cd_pin_h8homlet>;
+       vmmc-supply = <&reg_vcc3v0>;
+       cd-gpios = <&pio 5 6 GPIO_ACTIVE_HIGH>; /* PF6 */
+       bus-width = <4>;
+       cd-inverted;
+       status = "okay";
+};
+
 &uart0 {
        pinctrl-names = "default";
        pinctrl-0 = <&uart0_pins_b>;
-- 
1.9.1