On 10/02/16 16:16, Ludovic Desroches wrote: > On Wed, Feb 10, 2016 at 03:00:09PM +0200, Adrian Hunter wrote: >> On 10/02/16 14:51, Ludovic Desroches wrote: >>> Hi Adrian, >>> >>> On Wed, Feb 10, 2016 at 01:50:44PM +0200, Adrian Hunter wrote: >>>> On 10/02/16 11:58, Ludovic Desroches wrote: >>>>> By putting the device in suspend at the end of the probe, it is >>>>> impossible to wake up on non software event such as card >>>>> insertion/removal. >>>>> >>>>> Signed-off-by: Ludovic Desroches <ludovic.desroc...@atmel.com> >>>>> --- >>>>> >>>>> Hi, >>>>> >>>>> Since I had no feedback on this topic: >>>>> http://permalink.gmane.org/gmane.linux.kernel.mmc/35160 >>>>> >>>>> I would like to no more put the device in suspend at the end of the >>>>> probe. If >>>>> my device is suspended at the end of the probe, I have no issue to resume >>>>> on >>>>> a software event such as mounting my sdcard but hardware event such as >>>>> card >>>>> insertion and removal do not trigger a resume. >>>> >>>> You can't use runtime PM unless you have a way to wake-up. >>>> >>> >>> Thanks for your feedback. I am a bit disappointed since Ulf advised me to >>> use >>> runtime PM instead of system PM. >>> >>>> Currently, sdhci disables card detect interrupts when runtime suspended, >>>> and drivers use a card-detect GPIO to wake-up. >>>> >>> >>> It is what I have seen going through the sdhci layer. So next question is: >>> is it normal to not take care of card detect interrupts? We keep enabled >>> some IRQs probably for SDIO modules IRQ but not for card detection. I >>> don't understand the reason. >> >> Does sdhci-of-at91.c generate card detect interrupts while runtime suspended? > > It could if I keep one or two clocks enabled (need extra tests to be > sure about the clock needed to get this interrupt). I have tried to modify > quickly sdhci_runtime_suspend_host() to enable card insertion/removal, > there is an irq generated but the kernel complains this irq is not > handled. I didn't dig further, it was only to do a simple test.
sdhci_irq() returns immediately if (host->runtime_suspended && !sdhci_sdio_irq_enabled(host))