Hi, Im using Linux 2.6.14-omap-2430ONLY linux which i downloaded for linux.omap.com (This kernel is a TI specific kernel maintained internally by TI)
Im using a TI 2430 SDP board. This kernel, im able to boot in NOR flash, but not in NAND flash. However, im able to boot 2.6.19 in NOR and NAND without any problem. So, i presume, there is no problem with u-boot bootloader. I dont understand why the same kernel with the same bootargs boots in NOR, but not in NAND. All i get is -- OMAP243X SDP # bootm ## Booting image at 80000000 ... Image Name: Linux Kernel Image Image Type: ARM Linux Kernel Image (gzip compressed) Data Size: 1404634 Bytes = 1.3 MB Load Address: 80c08000 Entry Point: 80c08000 Verifying Checksum ... OK Uncompressing Kernel Image ... OK Starting kernel ... Uncompressing Linux.............................................................................................. done, booting the kernel. I dont know how to debug - since, immediately after i get 'booting the kernel' it hangs. how does one debug? Do i need to check any specific configuration option?. Should i need to enable a few options in make menuconfig for nand booting? Any advices, Regards, sriram - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
