Did I forget something when this was not accepted? S pozdravom / Best regards Daniel Kucera.
2016-02-21 15:41 GMT+01:00 Daniel Kucera <[email protected]>: > Hello all, > > I made a patch to add support for Prolific PL-27A1 host-to-host USB 3.0 link > cable. It's the same platform as PL-25A1 but with USB3.0 interface so > basically I only added right vendor/device id to get detected. Maximum > throughput I managed to get was about 1.5Gbps using iperf. I'll investigate > usbnet to get even higher throughput, if you have any tips where to look, > let me know. > > Developed and tested under 4.2.0-25. > > Best regards > Daniel Kucera. > > > diff --git a/drivers/net/usb/plusb.c b/drivers/net/usb/plusb.c > index 1bfe0fc..1239239 100644 > --- a/drivers/net/usb/plusb.c > +++ b/drivers/net/usb/plusb.c > @@ -102,7 +102,7 @@ static int pl_reset(struct usbnet *dev) > } > > static const struct driver_info prolific_info = { > - .description = "Prolific PL-2301/PL-2302/PL-25A1", > + .description = "Prolific PL-2301/PL-2302/PL-25A1/PL-27A1", > .flags = FLAG_POINTTOPOINT | FLAG_NO_SETINT, > /* some PL-2302 versions seem to fail usb_set_interface() */ > .reset = pl_reset, > @@ -139,6 +139,15 @@ static const struct usb_device_id products [] = { > * Host-to-Host Cable > */ > .driver_info = (unsigned long) &prolific_info, > + > +}, > + > +/* super speed cables */ > +{ > + USB_DEVICE(0x067b, 0x27a1), /* goobay Active USB 3.0 Data Link > + * Cable (PL-27A1) > + */ > + .driver_info = (unsigned long) &prolific_info, > }, > > { }, // END > @@ -158,5 +167,5 @@ static struct usb_driver plusb_driver = { > module_usb_driver(plusb_driver); > > MODULE_AUTHOR("David Brownell"); > -MODULE_DESCRIPTION("Prolific PL-2301/2302/25A1 USB Host to Host Link > Driver"); > +MODULE_DESCRIPTION("Prolific PL-2301/2302/25A1/27A1 USB Host to Host Link > Driver"); > MODULE_LICENSE("GPL"); >
