On 04.07.2016 18:21, Lukas Wunner wrote:
On Mon, Jul 04, 2016 at 06:04:42PM +0300, Mathias Nyman wrote:
On 04.07.2016 17:25, Rafael J. Wysocki wrote:
On Mon, Jul 4, 2016 at 4:26 PM, Mathias Nyman <mathias.ny...@linux.intel.com> 
wrote:
AceLan Kao can get his DELL XPS 13 laptop to hang by plugging/un-plugging
a USB 3.1 key via thunderbolt port.

Allocating memory fails after this, always pointing to NULL pointer or
page request failing in get_freepointer() called by
kmalloc/kmem_cache_alloc.

Unplugging a usb type-c device from the thunderbolt port on Alpine Ridge
based systems like this one will hotplug remove PCI bridges together
with the USB xhci controller behind them.

Yes, that matches with the lspci output you've posted, the whole
Thunderbolt controller is gone after unplug. Perhaps it's powered
down? What does "lspci -vvvv -s 00:1d.6" say? (Does the root port
still have a link to the Thunderbolt controller?)



"lspci -vvvv -s 00:1d.6" after unplug (on my working DELL XPS)


00:1d.6 PCI bridge: Intel Corporation Sunrise Point-H PCI Express Root Port #15 
(rev f1) (prog-if 00 [Normal decode])
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- 
Stepping- SERR- FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- 
<MAbort- >SERR- <PERR- INTx-
        Latency: 0
        Interrupt: pin C routed to IRQ 18
        Bus: primary=00, secondary=06, subordinate=3e, sec-latency=0
        I/O behind bridge: 00002000-00002fff
        Memory behind bridge: c4000000-da0fffff
        Prefetchable memory behind bridge: 0000000080000000-00000000a1ffffff
        Secondary status: 66MHz- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- 
<MAbort+ <SERR- <PERR-
        BridgeCtl: Parity- SERR- NoISA- VGA- MAbort- >Reset- FastB2B-
                PriDiscTmr- SecDiscTmr- DiscTmrStat- DiscTmrSERREn-
        Capabilities: [40] Express (v2) Root Port (Slot+), MSI 00
                DevCap: MaxPayload 256 bytes, PhantFunc 0
                        ExtTag- RBE+
                DevCtl: Report errors: Correctable- Non-Fatal- Fatal- 
Unsupported-
                        RlxdOrd- ExtTag- PhantFunc- AuxPwr- NoSnoop-
                        MaxPayload 128 bytes, MaxReadReq 128 bytes
                DevSta: CorrErr+ UncorrErr- FatalErr- UnsuppReq- AuxPwr+ 
TransPend-
                LnkCap: Port #15, Speed 8GT/s, Width x2, ASPM L0s L1, Exit Latency 
L0s <1us, L1 <16us
                        ClockPM- Surprise- LLActRep+ BwNot+ ASPMOptComp+
                LnkCtl: ASPM Disabled; RCB 64 bytes Disabled- CommClk+
                        ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-
                LnkSta: Speed 2.5GT/s, Width x2, TrErr- Train- SlotClk+ 
DLActive- BWMgmt+ ABWMgmt-
                SltCap: AttnBtn- PwrCtrl- MRL- AttnInd- PwrInd- HotPlug+ 
Surprise+
                        Slot #18, PowerLimit 25.000W; Interlock- NoCompl+
                SltCtl: Enable: AttnBtn- PwrFlt- MRL- PresDet+ CmdCplt- HPIrq- 
LinkChg-
                        Control: AttnInd Unknown, PwrInd Unknown, Power- 
Interlock-
                SltSta: Status: AttnBtn- PowerFlt- MRL- CmdCplt- PresDet- 
Interlock-
                        Changed: MRL- PresDet- LinkState+
                RootCtl: ErrCorrectable- ErrNon-Fatal- ErrFatal- PMEIntEna- 
CRSVisible-
                RootCap: CRSVisible-
                RootSta: PME ReqID 0000, PMEStatus- PMEPending-
                DevCap2: Completion Timeout: Range ABC, TimeoutDis+, LTR+, OBFF 
Not Supported ARIFwd+
                DevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis-, LTR-, 
OBFF Disabled ARIFwd-
                LnkCtl2: Target Link Speed: 2.5GT/s, EnterCompliance- SpeedDis-
                         Transmit Margin: Normal Operating Range, 
EnterModifiedCompliance- ComplianceSOS-
                         Compliance De-emphasis: -6dB
                LnkSta2: Current De-emphasis Level: -3.5dB, 
EqualizationComplete-, EqualizationPhase1-
                         EqualizationPhase2-, EqualizationPhase3-, 
LinkEqualizationRequest-
        Capabilities: [80] MSI: Enable- Count=1/1 Maskable- 64bit-
                Address: 00000000  Data: 0000
        Capabilities: [90] Subsystem: Dell Sunrise Point-H PCI Express Root Port
        Capabilities: [a0] Power Management version 3
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA 
PME(D0+,D1-,D2-,D3hot+,D3cold+)
                Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
        Capabilities: [100 v1] Advanced Error Reporting
                UESta:  DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- 
RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-
                UEMsk:  DLP- SDES- TLP- FCP- CmpltTO+ CmpltAbrt- UnxCmplt+ 
RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-
                UESvrt: DLP+ SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- 
RxOF+ MalfTLP+ ECRC- UnsupReq- ACSViol-
                CESta:  RxErr+ BadTLP- BadDLLP- Rollover+ Timeout+ NonFatalErr+
                CEMsk:  RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr+
                AERCap: First Error Pointer: 00, GenCap- CGenEn- ChkCap- ChkEn-
        Capabilities: [140 v1] Access Control Services
                ACSCap: SrcValid+ TransBlk+ ReqRedir+ CmpltRedir+ UpstreamFwd- 
EgressCtrl- DirectTrans-
                ACSCtl: SrcValid- TransBlk- ReqRedir- CmpltRedir- UpstreamFwd- 
EgressCtrl- DirectTrans-
        Capabilities: [200 v1] L1 PM Substates
                L1SubCap: PCI-PM_L1.2+ PCI-PM_L1.1+ ASPM_L1.2+ ASPM_L1.1+ 
L1_PM_Substates+
                          PortCommonModeRestoreTime=40us PortTPowerOnTime=10us
        Capabilities: [220 v1] #19
        Kernel driver in use: pcieport
        Kernel modules: shpchp


AceLan Kao, can you confirm your lspci output looks similar on the failing DELL 
XPS?

-Mathias

Reply via email to