On Monday 11 July 2016 02:26 PM, dawei chien wrote:
Dear Keerthy,
On Thu, 2016-07-07 at 17:39 +0530, Keerthy wrote:
On Thursday 07 July 2016 02:36 PM, Dawei Chien wrote:
This adds the thermal controller and auxadc nodes
to the Mediatek MT2701 dtsi file.
Signed-off-by: Dawei Chien <dawei.ch...@mediatek.com>
---
This patch depned on:
https://patchwork.kernel.org/patch/9213545/
---
arch/arm/boot/dts/mt2701.dtsi | 43
+++++++++++++++++++++++++++++++++++++++++
1 file changed, 43 insertions(+)
diff --git a/arch/arm/boot/dts/mt2701.dtsi b/arch/arm/boot/dts/mt2701.dtsi
index 2ac8b50..0834a23 100644
--- a/arch/arm/boot/dts/mt2701.dtsi
+++ b/arch/arm/boot/dts/mt2701.dtsi
@@ -77,6 +77,36 @@
#clock-cells = <0>;
};
+ thermal-zones {
+ cpu_thermal: cpu_thermal {
+ polling-delay-passive = <1000>; /* milliseconds */
+ polling-delay = <1000>; /* milliseconds */
+
+ thermal-sensors = <&thermal 0>;
+ sustainable-power = <1000>;
+
+ trips {
+ threshold: trip-point@0 {
+ temperature = <68000>;
+ hysteresis = <2000>;
+ type = "passive";
+ };
+
+ target: trip-point@1 {
+ temperature = <85000>;
+ hysteresis = <2000>;
+ type = "passive";
+ };
+
+ cpu_crit: cpu_crit@0 {
+ temperature = <115000>;
+ hysteresis = <2000>;
+ type = "critical";
+ };
+ };
+ };
+ };
+
are there any corresponding cooling-maps?
Since MT2701 does not register CPUFREQ cooling device and its' own
device node, I could not add cooling-maps so far.
Could we add cooling map after CPUFREQ ready, thank you.
Okay. I was curious to know about the cooling agents.
timer {
compatible = "arm,armv7-timer";
interrupt-parent = <&gic>;
@@ -183,4 +213,17 @@
clocks = <&uart_clk>;
status = "disabled";
};
+
+ thermal: thermal@1100b000 {
+ #thermal-sensor-cells = <0>;
+ compatible = "mediatek,mt2701-thermal";
+ reg = <0 0x1100b000 0 0x1000>;
+ interrupts = <GIC_SPI 70 IRQ_TYPE_LEVEL_LOW>;
+ clocks = <&pericfg CLK_PERI_THERM>, <&pericfg CLK_PERI_AUXADC>;
+ clock-names = "therm", "auxadc";
+ resets = <&pericfg 0x10>;
+ reset-names = "therm";
+ mediatek,auxadc = <&auxadc>;
+ mediatek,apmixedsys = <&apmixedsys>;
+ };
};
