Hi, Bin Gao <[email protected]> writes: > This patch implements a simple USB Power Delivery sink port state machine. > It assumes the hardware only handles PD packet transmitting and receiving > over the CC line of the USB Type-C connector. The state transition is > completely controlled by software. This patch only implement the sink port > function and it doesn't support source port and port swap yet. > > This patch depends on these two patches: > https://lkml.org/lkml/2016/6/29/349 > https://lkml.org/lkml/2016/6/29/350 > > Signed-off-by: Bin Gao <[email protected]> > Changes in v2: > - Removed work queue so messages are directly handled in phy driver's > interrupt context > - used pr_debug instead of pr_info for message dump > - Converted PD driver to tristate and typec driver is independent of it
this should be after the tearline (---) below. We don't want this in
changelog ;-)
> +static void handle_source_cap(struct pd_sink_port *port, u8 msg_revision,
> + u8 nr_objs, u8 *buf)
> +{
> + int i;
> + u32 *obj;
> + u8 type;
> + struct pd_source_cap *cap = port->source_caps;
> +
> + /*
> + * The PD spec revision included in SOURCE_CAPABILITY message is the
> + * highest revision that the Source supports.
> + */
> + port->pd_rev = msg_revision;
> +
> + /*
> + * First we need to save all PDOs - they may be used in the future.
> + * USB PD spec says we must use PDOs in the most recent
> + * SOURCE_CAPABILITY message. Here we replace old PDOs with new ones.
> + */
> + port->nr_source_caps = 0;
> + for (i = 0; i < nr_objs; i++) {
> + obj = (u32 *)(buf + i * PD_OBJ_SIZE);
> + type = (*obj >> SOURCE_CAP_TYPE_BIT) & SOURCE_CAP_TYPE_MASK;
> + switch (type) {
> + case PS_TYPE_FIXED:
> + cap->ps_type = PS_TYPE_FIXED;
> + cap->fixed = *(struct pd_pdo_src_fixed *)obj;
> + break;
> + case PS_TYPE_VARIABLE:
> + cap->ps_type = PS_TYPE_VARIABLE;
> + cap->variable = *(struct pd_pdo_variable *)obj;
> + break;
> + case PS_TYPE_BATTERY:
> + cap->ps_type = PS_TYPE_BATTERY;
> + cap->battery = *(struct pd_pdo_battery *)obj;
> + break;
> + default: /* shouldn't come here */
> + pr_err("Invalid Source Capability type: %u.\n", type);
> + continue;
> + }
> + port->nr_source_caps++;
> + cap++;
> + }
> +
> + if (port->nr_source_caps == 0) {
> + pr_err("There is no valid PDOs in SOURCE_CAPABILITY message\n");
> + return;
> + }
> +
> + /* If a contract is not established, we need send a REQUEST message */
> + if (port->state == PD_SINK_STATE_WAIT_FOR_SRC_CAP) {
this is wrong. Read the fluxchart in figure 8-42. Source can decide to
send another Source Capability before receiving our Good CRC and we need
to work with that. This state check is, at a minimum, wrong. I'd
actually just go ahead and remove it.
> + if (!send_request(port))
> + port->state = PD_SINK_STATE_REQUEST_SENT;
> + }
> +}
--
balbi
signature.asc
Description: PGP signature
