One more comment below.
On Tue, Jun 28, 2016 at 02:54:44PM +0200, [email protected] wrote:
> +&iomuxc {
> + pinctrl_esdhc1: esdhc1grp {
> + fsl,pins = <
> + MX53_PAD_SD1_DATA0__ESDHC1_DAT0 0x1d5
> + MX53_PAD_SD1_DATA1__ESDHC1_DAT1 0x1d5
> + MX53_PAD_SD1_DATA2__ESDHC1_DAT2 0x1d5
> + MX53_PAD_SD1_DATA3__ESDHC1_DAT3 0x1d5
> + MX53_PAD_SD1_CMD__ESDHC1_CMD 0x1d5
> + MX53_PAD_SD1_CLK__ESDHC1_CLK 0x1d5
> + >;
> + };
> +
> + pinctrl_i2c1_pmic: i2c1grp_pmic {
> + fsl,pins = <
> + MX53_PAD_EIM_D21__I2C1_SCL 0x0
> + MX53_PAD_EIM_D28__I2C1_SDA 0x0
Please use a proper pin configuration value rather than 0x0.
> + >;
> + };
> +
> + pinctrl_led: led {
> + fsl,pins = <
> + MX53_PAD_DISP0_DAT6__GPIO4_27 0x0
Ditto.
Shawn
> + >;
> + };
