My PPC with an ACARD addon PPC card. AEC6260R: IDE controller on PCI bus 00 dev 68 AEC6260R: chipset revision 1 AEC6260R: not 100% native mode: will probe irqs later AEC6260R: ROM enabled at 0x80810000 ide0: BM-DMA at 0x0800-0x0807, BIOS settings: hda:pio, hdb:pio ide1: BM-DMA at 0x0808-0x080f, BIOS settings: hdc:pio, hdd:pio What is your chipset, CMD646 rev 5 Ultra DMA 33 ??? Andre Hedrick CTO Timpanogas Research Group EVP Linux Development, TRG Linux ATA Development
Cannot find map file. No module symbols loaded. klogd 1.3-3, log source = ksyslog started. <4>Total memory = 112MB; using 512kB for hash table (at c0300000) <4>Linux version 2.4.0-test9 (root@ppc) (gcc version 2.95.2 19991024 (release)) #1 Thu Oct 5 02:02:51 PDT 2000 <6>PCI bus 0 controlled by bandit at f2000000 <6>Cache coherency enabled for bandit/PSX at fdef1000 <6>PCI bus 1 controlled by chaos at f0000000 <4>On node 0 totalpages: 28672 <4>zone(0): 28672 pages. <4>zone(1): 0 pages. <4>zone(2): 0 pages. <4>Kernel command line: root=/dev/hda7 devfs=nomount <4>System has 32 possible interrupts <4>GMT Delta read from XPRAM: -420 minutes, DST: on <6>via_calibrate_decr: ticks per jiffy = 111227 (667364 ticks) <4>Console: colour dummy device 80x25 <4>Calibrating delay loop... 532.48 BogoMIPS <4>Memory: 109080k available (1876k kernel code, 904k data, 268k init, 0k highmem) <4>Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes) <4>Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes) <4>Page-cache hash table entries: 32768 (order: 5, 131072 bytes) <4>Inode-cache hash table entries: 8192 (order: 4, 65536 bytes) <5>VFS: Diskquotas version dquot_6.4.0 initialized <4>POSIX conformance testing by UNIFIX <4>PCI: Probing PCI hardware <4>Macintosh CUDA driver v0.5 for Unified ADB. <6>Linux NET4.0 for Linux 2.4 <6>Based upon Swansea University Computer Society NET3.039 <6>NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. <6>NET4: Linux TCP/IP 1.0 for NET4.0 <6>IP Protocols: ICMP, UDP, TCP, IGMP <4>IP: routing cache hash table of 512 buckets, 4Kbytes <4>TCP: Hash tables configured (established 8192 bind 8192) <6>NET4: AppleTalk 0.18 for Linux NET4.0 <4>Initializing RT netlink socket <4>Starting kswapd v1.8 <6>controlfb: Memory bank 1 present, bank 2 present, total VRAM 4MB <6>Monitor sense value = 0x623, using video mode 18 and color mode 0. <4>Console: switching to colour frame buffer device 144x54 <6>fb0: control display adapter <6>MacOS display is /chaos/control <4>PowerMac Z8530 serial driver version 2.0 <4>tty00 at 0xc8805020 (irq = 15) is a Z8530 ESCC, port = modem <4>tty01 at 0xc880c000 (irq = 16) is a Z8530 ESCC, port = printer <4>pty: 256 Unix98 ptys configured <4>RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize <6>loop: enabling 8 loop devices <6>Uniform Multi-Platform E-IDE driver Revision: 6.31 <4>ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx <4>AEC6260R: IDE controller on PCI bus 00 dev 68 <4>AEC6260R: chipset revision 1 <4>AEC6260R: not 100% native mode: will probe irqs later <4>AEC6260R: ROM enabled at 0x80810000 <4> ide0: BM-DMA at 0x0800-0x0807, BIOS settings: hda:pio, hdb:pio <4> ide1: BM-DMA at 0x0808-0x080f, BIOS settings: hdc:pio, hdd:pio <4>hda: QUANTUM FIREBALL CX10.2A, ATA DISK drive <4>ide0 at 0x840-0x847,0x000 on irq 23 <4>ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx <6>hda: 20044080 sectors (10263 MB) w/418KiB Cache, CHS=19885/16/63, UDMA(66) <6>Partition check: <6> /dev/ide/host0/bus0/target0/lun0: [mac] p1 p2 p3 p4 p5 p6 p7 p8 p9 p10 <6>fd0: SWIM3 floppy controller <5>udf: registering filesystem <6>Macintosh ADB mouse driver installed. <7>IN from bad port 71 at c02600a0 <6>Real Time Clock Driver v1.10c <6>Linux Tulip driver version 0.9.10 (September 6, 2000) <4>PCI: Enabling device 00:0f.0 (0004 -> 0007) <6>eth0: Lite-On 82c168 PNIC rev 32 at 0x400, 00:00:B5:94:AB:39, IRQ 25. <6>eth0: MII transceiver #1 config 3100 status 7829 advertising 01e1. <6>eth1: MACE at 00:05:02:58:9d:48, chip revision 25.64 <4>scsi0 : MESH <4>mesh: rejecting message from target 1: 1 1 3 <4>mesh: bs0=2f in msg_out <4>mesh: rejecting message from target 1: 1 1 32 <4>mesh: bs0=2f in msg_out <4>mesh: rejecting message from target 1: f <4> Vendor: SEAGATE Model: ST32550N Rev: 0011 <4> Type: Direct-Access ANSI SCSI revision: 02 <6>mesh: target 3 synchronous at 5.0 MB/s <4> Vendor: MATSHITA Model: CD-ROM CR-8008 Rev: 8.0h <4> Type: CD-ROM ANSI SCSI revision: 02 <4>scsi1 : 53C94 <4> Vendor: MAXTOR Model: LXT-213S SUN0207 Rev: 4.15 <4> Type: Direct-Access ANSI SCSI revision: 01 CCS <4>Detected scsi disk sda at scsi0, channel 0, id 1, lun 0 <4>Detected scsi disk sdb at scsi1, channel 0, id 6, lun 0 <4>SCSI device sda: 4194303 512-byte hdwr sectors (2147 MB) <6> /dev/scsi/host0/bus0/target1/lun0: [mac] p1 p2 p3 p4 p5 p6 p7 p8 p9 <4>sdb: Spinning up disk..............ready <4>SCSI device sdb: 415436 512-byte hdwr sectors (213 MB) <6> /dev/scsi/host1/bus0/target6/lun0: [mac] p1 p2 p3 p4 <4>Detected scsi CD-ROM sr0 at scsi0, channel 0, id 3, lun 0 <6>Uniform CD-ROM driver Revision: 3.11 <7>adb devices: [2]: 2 2 [3]: 3 1 <4>ADB keyboard at 2, handler set to 3 <4>ADB mouse at 3, handler set to 2 <4>devfs: devfs_register(): device already registered: "rtc" <6>Macintosh non-volatile memory driver v1.0 <4>devfs: v0.102 (20000622) Richard Gooch ([EMAIL PROTECTED]) <4>devfs: boot_options: 0x2 <3>kmem_create: Forcing size word alignment - nfs_fh <4>VFS: Mounted root (ext2 filesystem) readonly. <4>Freeing unused kernel memory: 268k init 8k chrp 36k prep Kernel logging (ksyslog) stopped. Kernel log daemon terminating.