On Sat, 2016-08-27 at 15:39 +0800, Zhuo-hao Lee wrote:
> There are several ways to set the SDA hold time for i2c controller,
> including: Device Tree, built-in device properties and ACPI. However,
> if the SDA hold time is not specified by above method, we should
> read the value, where it is preset by firmware, and save it to
> sda_hold_time. This is needed because when i2c controller enters
> runtime suspend, the DW_IC_SDA_HOLD value will be reset to chipset
> default value. And during runtime resume, i2c_dw_init will be called
> to reconfigure i2c controller. If sda_hold_time is zero, the chipset
> default hold time will be used, that will be too short for some
> platforms. Therefore, to have a better tolerance, the DW_IC_SDA_HOLD
> value should be kept by sda_hold_time.

Looks good to me.
Reviewed-by: Andy Shevchenko <andriy.shevche...@linux.intel.com>

> 
> Signed-off-by: Zhuo-hao Lee <zhuo-hao....@intel.com>
> ---
>  drivers/i2c/busses/i2c-designware-core.c | 16 ++++++++++------
>  1 file changed, 10 insertions(+), 6 deletions(-)
> 
> diff --git a/drivers/i2c/busses/i2c-designware-core.c
> b/drivers/i2c/busses/i2c-designware-core.c
> index c6922b8..fcd973d 100644
> --- a/drivers/i2c/busses/i2c-designware-core.c
> +++ b/drivers/i2c/busses/i2c-designware-core.c
> @@ -367,13 +367,17 @@ int i2c_dw_init(struct dw_i2c_dev *dev)
>       dev_dbg(dev->dev, "Fast-mode HCNT:LCNT = %d:%d\n", hcnt,
> lcnt);
>  
>       /* Configure SDA Hold Time if required */
> -     if (dev->sda_hold_time) {
> -             reg = dw_readl(dev, DW_IC_COMP_VERSION);
> -             if (reg >= DW_IC_SDA_HOLD_MIN_VERS)
> +     reg = dw_readl(dev, DW_IC_COMP_VERSION);
> +     if (reg >= DW_IC_SDA_HOLD_MIN_VERS) {
> +             if (dev->sda_hold_time) {
>                       dw_writel(dev, dev->sda_hold_time,
> DW_IC_SDA_HOLD);
> -             else
> -                     dev_warn(dev->dev,
> -                             "Hardware too old to adjust SDA hold
> time.");
> +             } else {
> +                     /* Keep previous hold time setting if no one
> set it */
> +                     dev->sda_hold_time = dw_readl(dev,
> DW_IC_SDA_HOLD);
> +             }
> +     } else {
> +             dev_warn(dev->dev,
> +                     "Hardware too old to adjust SDA hold
> time.\n");
>       }
>  
>       /* Configure Tx/Rx FIFO threshold levels */

-- 
Andy Shevchenko <andriy.shevche...@linux.intel.com>
Intel Finland Oy

Reply via email to