On Fri, Oct 7, 2016 at 9:17 PM, Bacchewar, Nilesh
<[email protected]> wrote:
> Here, Its marking  GPIO controller IRQ line as wake capable not GPIO lines.

AFAIU this is called per (GPIO) pin which is IRQ enabled.

Imagine a case when you have more than one such pin.

1. Set IRQ wake for pin 1
2. Set IRQ wake for pin 2 (assume that is pin under the question)
3. Unset IRQ wake for pin 1 (for some reason)
4. Global pinctrl IRQ wake is unset. Resulting same issue as before.

What did I miss above?

>
> Regards,
> Nilesh
>
> -----Original Message-----
> From: Andy Shevchenko [mailto:[email protected]]
> Sent: Friday, October 7, 2016 10:59 AM
> To: Bacchewar, Nilesh <[email protected]>
> Cc: Mika Westerberg <[email protected]>; Krogerus, Heikki 
> <[email protected]>; Linus Walleij <[email protected]>; 
> [email protected]; [email protected]
> Subject: Re: [PATCH] pinctrl: intel: Configure GPIO chip IRQ as wakeup 
> interrupts
>
> On Thu, Sep 22, 2016 at 2:03 AM, Nilesh Bacchewar 
> <[email protected]> wrote:
>> On some Intel BXT platform, wake-up from suspend-to-idle on pressing
>> power-button is not working. Its noticed that gpio-keys driver marking
>> the second level IRQ/power-button as wake capable but Intel pintctrl
>> driver is missing to mark GPIO chip/controller IRQ which first level
>> IRQ as wake cable if its GPIO pin IRQ is wakeble. So, though the first
>> level IRQ gets generated on power-button press, since it is not marked
>> as wake capable resume/wake-up flow is not happening.
>> Intel pintctrl/GPIO driver need to mark GPIO chip/controller IRQ
>> (first level IRQ) as wake capable iff GPIO pin's IRQ (second level
>> IRQ) is marked as wake cable.
>
>>         if (on)
>> -               gpe_en |= BIT(gpp_offset);
>> +               enable_irq_wake(pctrl->irq);
>>         else
>> -               gpe_en &= ~BIT(gpp_offset);
>> -       writel(gpe_en, community->regs + GPI_GPE_EN + gpp * 4);
>> -
>> -       raw_spin_unlock_irqrestore(&pctrl->lock, flags);
>> +               disable_irq_wake(pctrl->irq);
>
> Shouldn't be refcounting here or I missed something?
> What I think of is 2+ GPIO lines marked as wake capable IRQ sources and one 
> of them is disabled earlier by some reason.
>
> --
> With Best Regards,
> Andy Shevchenko



-- 
With Best Regards,
Andy Shevchenko

Reply via email to