On Sun, Dec 4, 2016 at 11:07 PM, Milo Kim <woogyom....@gmail.com> wrote:
> + regulators { > + compatible = "simple-bus"; > + #address-cells = <1>; > + #size-cells = <0>; > + > + reg_3p3v: regulator@0 { > + compatible = "regulator-fixed"; > + reg = <0>; > + regulator-name = "3P3V"; > + regulator-min-microvolt = <3300000>; > + regulator-max-microvolt = <3300000>; > + regulator-always-on; > + }; Please remove the regulators container and put the regulator node directly as follows: reg_3p3v: regulator-3p3v { compatible = "regulator-fixed"; regulator-name = "3P3V"; regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; regulator-always-on; } > + }; > +}; > + > +&clks { > + assigned-clocks = <&clks IMX6QDL_CLK_LDB_DI0_SEL>, > + <&clks IMX6QDL_CLK_LDB_DI1_SEL>; > + assigned-clock-parents = <&clks IMX6QDL_CLK_PLL3_USB_OTG>, > + <&clks IMX6QDL_CLK_PLL3_USB_OTG>; > +}; > + > +&fec { > + phy-mode = "rgmii"; > + phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_HIGH>; I think you meant phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>; > +&iomuxc { > + savageboard { > + pinctrl_emmc: emmcgrp { > + fsl,pins = < > + MX6QDL_PAD_SD4_CMD__SD4_CMD > 0x17059 > + MX6QDL_PAD_SD4_CLK__SD4_CLK > 0x10059 > + MX6QDL_PAD_SD4_DAT0__SD4_DATA0 > 0x17059 > + MX6QDL_PAD_SD4_DAT1__SD4_DATA1 > 0x17059 > + MX6QDL_PAD_SD4_DAT2__SD4_DATA2 > 0x17059 > + MX6QDL_PAD_SD4_DAT3__SD4_DATA3 > 0x17059 > + MX6QDL_PAD_SD4_DAT4__SD4_DATA4 > 0x17059 > + MX6QDL_PAD_SD4_DAT5__SD4_DATA5 > 0x17059 > + MX6QDL_PAD_SD4_DAT6__SD4_DATA6 > 0x17059 > + MX6QDL_PAD_SD4_DAT7__SD4_DATA7 > 0x17059 > + >; > + }; You can remove the savegeboard level. Please check arch/arm/boot/dts/imx6q-tbs2910.dts. iomux usually go as the last node of the dts file.