Each serial port which supports HW flow-control should have 2 Pinctrl
groups. One for when HW flow-control is in progress, where the IP
will take over controlling the lines and another group which enables
the lines to be toggled using GPIO mechanisms.
Acked-by: Peter Griffin <peter.grif...@linaro.org>
Signed-off-by: Lee Jones <lee.jo...@linaro.org>
---
arch/arm/boot/dts/stih407-pinctrl.dtsi | 12 ++++++++++--
1 file changed, 10 insertions(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/stih407-pinctrl.dtsi
b/arch/arm/boot/dts/stih407-pinctrl.dtsi
index daab16b..bd1a82e 100644
--- a/arch/arm/boot/dts/stih407-pinctrl.dtsi
+++ b/arch/arm/boot/dts/stih407-pinctrl.dtsi
@@ -465,8 +465,16 @@
serial0 {
pinctrl_serial0: serial0-0 {
st,pins {
- tx = <&pio17 0 ALT1 OUT>;
- rx = <&pio17 1 ALT1 IN>;
+ tx = <&pio17 0 ALT1 OUT>;
+ rx = <&pio17 1 ALT1 IN>;
+ };
+ };
+ pinctrl_serial0_hw_flowctrl:
serial0-0_hw_flowctrl {
+ st,pins {
+ tx = <&pio17 0 ALT1 OUT>;
+ rx = <&pio17 1 ALT1 IN>;
+ cts = <&pio17 2 ALT1 IN>;
+ rts = <&pio17 3 ALT1 OUT>;
};
};
};
--
2.9.3
