On 03/10/2017 03:09 PM, Artur Jedrysek wrote: CCing Dinh.
[...] >>>>> + /* Determine, whether or not octal transfer MAY be supported */ >>>> >>>> But you already know that from DT, no ? >>>> >>> >>> Cadence Octal (formerly Quad) SPI Controller is sold as an IP, and is >>> configurable. This includes max SPI mode. It is possible to detect, that >>> Octal SPI controller is configured (during hardware compilation) to support >>> up to Quad mode, using revision register. >> >> So the octal-spi controller always has this config register, but the >> quad-spi controller may or may not have this register ? >> > > This register was always present. In Quad-SPI, however, it didn't contain > information about maximum possible mode, as only quad was possible, and > meaning of bits checked here was different. OK >>>>> + rev_reg = readl(cqspi->iobase + CQSPI_REG_MODULEID); >>>>> + dev_info(dev, "CQSPI Module id %x\n", rev_reg); >>>>> + >>>>> + switch (rev_reg & CQSPI_REG_MODULEID_CONF_ID_MASK) { >>>>> + case CQSPI_REG_MODULEID_CONF_ID_OCTAL_PHY: >>>>> + case CQSPI_REG_MODULEID_CONF_ID_OCTAL: >>>>> + mode = SPI_NOR_OCTAL; >>>>> + break; >>>>> + case CQSPI_REG_MODULEID_CONF_ID_QUAD: >>>>> + case CQSPI_REG_MODULEID_CONF_ID_QUAD_PHY: >>>> >>>> Does this work on all revisions of CQSPI ? >>>> >>> >>> After having a more thorough look at specification of older IP version >>> (quad only) it seems, that revision register format has indeed changed. >>> This will be fixed in the next version of the patch. >> >> Can the quad-spi controller be configured only as dual or single ? >> What about the octal one ? These cases should probably be handled >> somehow too, right ? >> > > Quad-SPI controller can always support single, dual and quad. There was > no option to configure max mode. Octal-SPI controller can be configured > to support either octal or quad mode. No controller could be configured > (during hardware compilation/synthesis) to support only single/dual > SPI mode. To put it shortly: single, dual and quad is always supported. So basically the whole check you need to perform here is mode = quad; if (controller->flags & CAN_DO_OCTAL) { if (readl(ID_REGISTER) & IS_CONFIGURED_AS_OCTAL) mode = octal; } -- Best regards, Marek Vasut