On Fri, Mar 24, 2017 at 4:22 PM, Jacopo Mondi <jacopo+rene...@jmondi.org> wrote:
I assume Geert will queue this driver even if it is outside of sh-pfc?
> Add combined gpio and pin controller driver for Renesas RZ/A1
> r7s72100 SoC.
>
> Signed-off-by: Jacopo Mondi <jacopo+rene...@jmondi.org>
> ---
> drivers/pinctrl/Kconfig | 10 +
> drivers/pinctrl/Makefile | 1 +
> drivers/pinctrl/pinctrl-rza1.c | 961
> +++++++++++++++++++++++++++++++++++++++++
So this is very different from the SH-PFC family and should not
be in drivers/pinctrl/sh-pfc?
> +config PINCTRL_RZA1
> + bool "Renesas RZ/A1 gpio and pinctrl driver"
> + depends on OF
> + depends on ARCH_R7S72100 || COMPILE_TEST
> + select GENERIC_PINCTRL_GROUPS
> + select GENERIC_PINMUX_FUNCTIONS
> + select GENERIC_PINCONF
If it is also a GPIO driver I guess it should
select GPIOLIB as well.
This was not possible in the past, but it is possible nowadays.
> +struct gpio_chip rza1_gpiochip_template = {
> + .request = rza1_gpio_request,
> + .free = rza1_gpio_free,
> + .get_direction = rza1_gpio_get_direction,
> + .direction_input = rza1_gpio_direction_input,
> + .direction_output = rza1_gpio_direction_output,
> + .get = rza1_gpio_get,
> + .set = rza1_gpio_set,
> +};
We now also have .set_multiple() and more interestingly
.set_config() which can be backed by pinctrl if you want
to e.g. support debouncing and/or open drain/open source.
Maybe this is stuff your pin controller can do, but not needed
in the initial submission for sure.
> +static int rza1_pinmux_set(struct pinctrl_dev *pctldev, unsigned int
> selector,
> + unsigned int group)
Please name it rza1_set_mux() to correspond with the ops field.
Yours,
Linus Walleij
