Update BRCM SATA phy dt-binding documentation for stingray.
Signed-off-by: Srinath Mannam <[email protected]>
Reviewed-by: Ray Jui <[email protected]>
Reviewed-by: Scott Branden <[email protected]>
---
Documentation/devicetree/bindings/phy/brcm-sata-phy.txt | 7 ++++---
1 file changed, 4 insertions(+), 3 deletions(-)
diff --git a/Documentation/devicetree/bindings/phy/brcm-sata-phy.txt
b/Documentation/devicetree/bindings/phy/brcm-sata-phy.txt
index 6ccce09..97977cd 100644
--- a/Documentation/devicetree/bindings/phy/brcm-sata-phy.txt
+++ b/Documentation/devicetree/bindings/phy/brcm-sata-phy.txt
@@ -7,12 +7,13 @@ Required properties:
"brcm,iproc-ns2-sata-phy"
"brcm,iproc-nsp-sata-phy"
"brcm,phy-sata3"
+ "brcm,iproc-sr-sata-phy"
- address-cells: should be 1
- size-cells: should be 0
- reg: register ranges for the PHY PCB interface
- reg-names: should be "phy" and "phy-ctrl"
The "phy-ctrl" registers are only required for
- "brcm,iproc-ns2-sata-phy".
+ "brcm,iproc-ns2-sata-phy" and "brcm,iproc-sr-sata-phy".
Sub-nodes:
Each port's PHY should be represented as a sub-node.
@@ -23,8 +24,8 @@ Sub-nodes required properties:
Sub-nodes optional properties:
- brcm,enable-ssc: use spread spectrum clocking (SSC) on this port
- This property is not applicable for "brcm,iproc-ns2-sata-phy" and
- "brcm,iproc-nsp-sata-phy".
+ This property is not applicable for "brcm,iproc-ns2-sata-phy",
+ "brcm,iproc-nsp-sata-phy" and "brcm,iproc-sr-sata-phy".
Example:
sata-phy@f0458100 {
--
2.7.4
