On Thursday 15 June 2017 12:03 PM, Keerthy wrote: > Add driver for lp87565 PMIC family GPIOs. Three GPIOs are supported > and can be configured in Open-drain output or Push-pull output. > > Signed-off-by: Keerthy <j-keer...@ti.com> > --- > > Latest version of mfd patch: > > https://patchwork.kernel.org/patch/9783079/
The latest version is pulled by Lee Jones. https://patchwork.kernel.org/patch/9783081/ Thanks, Keerthy > > Changes in v2: > > * included <linux/gpio/driver.h> > * stored the struct regmap *map instead of whole lp87565 struct > * clamped return values to [0,1] where necessary. > * Added more comments to explain the 2 modes. > * platform_set_drvdata(pdev, gpio) > > drivers/gpio/Kconfig | 10 +++ > drivers/gpio/Makefile | 1 + > drivers/gpio/gpio-lp87565.c | 190 > ++++++++++++++++++++++++++++++++++++++++++++ > 3 files changed, 201 insertions(+) > create mode 100644 drivers/gpio/gpio-lp87565.c > > diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig > index 2e7d9ff..f235eae 100644 > --- a/drivers/gpio/Kconfig > +++ b/drivers/gpio/Kconfig > @@ -965,6 +965,16 @@ config GPIO_LP873X > This driver can also be built as a module. If so, the module will be > called gpio-lp873x. > > +config GPIO_LP87565 > + tristate "TI LP87565 GPIO" > + depends on MFD_TI_LP87565 > + help > + This driver supports the GPIO on TI Lp873565 PMICs. 3 GPIOs are > present > + on LP87565 PMICs. > + > + This driver can also be built as a module. If so, the module will be > + called gpio-lp87565. > + > config GPIO_MAX77620 > tristate "GPIO support for PMIC MAX77620 and MAX20024" > depends on MFD_MAX77620 > diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile > index bcd0a0b..a9fda6c 100644 > --- a/drivers/gpio/Makefile > +++ b/drivers/gpio/Makefile > @@ -67,6 +67,7 @@ obj-$(CONFIG_GPIO_LP3943) += gpio-lp3943.o > obj-$(CONFIG_GPIO_LPC18XX) += gpio-lpc18xx.o > obj-$(CONFIG_ARCH_LPC32XX) += gpio-lpc32xx.o > obj-$(CONFIG_GPIO_LP873X) += gpio-lp873x.o > +obj-$(CONFIG_GPIO_LP87565) += gpio-lp87565.o > obj-$(CONFIG_GPIO_LYNXPOINT) += gpio-lynxpoint.o > obj-$(CONFIG_GPIO_MAX730X) += gpio-max730x.o > obj-$(CONFIG_GPIO_MAX7300) += gpio-max7300.o > diff --git a/drivers/gpio/gpio-lp87565.c b/drivers/gpio/gpio-lp87565.c > new file mode 100644 > index 0000000..6313c50 > --- /dev/null > +++ b/drivers/gpio/gpio-lp87565.c > @@ -0,0 +1,190 @@ > +/* > + * Copyright (C) 2017 Texas Instruments Incorporated - http://www.ti.com/ > + * Keerthy <j-keer...@ti.com> > + * > + * This program is free software; you can redistribute it and/or > + * modify it under the terms of the GNU General Public License version 2 as > + * published by the Free Software Foundation. > + * > + * This program is distributed "as is" WITHOUT ANY WARRANTY of any > + * kind, whether expressed or implied; without even the implied warranty > + * of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the > + * GNU General Public License version 2 for more details. > + * > + * Based on the LP873X driver > + */ > + > +#include <linux/gpio/driver.h> > +#include <linux/module.h> > +#include <linux/platform_device.h> > +#include <linux/regmap.h> > + > +#include <linux/mfd/lp87565.h> > + > +struct lp87565_gpio { > + struct gpio_chip chip; > + struct regmap *map; > +}; > + > +static int lp87565_gpio_get_direction(struct gpio_chip *chip, > + unsigned int offset) > +{ > + struct lp87565_gpio *gpio = gpiochip_get_data(chip); > + int ret, val; > + > + ret = regmap_read(gpio->map, LP87565_REG_GPIO_CONFIG, &val); > + if (ret < 0) > + return ret; > + > + return !(val & BIT(offset)); > +} > + > +static int lp87565_gpio_direction_input(struct gpio_chip *chip, > + unsigned int offset) > +{ > + struct lp87565_gpio *gpio = gpiochip_get_data(chip); > + > + return regmap_update_bits(gpio->map, > + LP87565_REG_GPIO_CONFIG, > + BIT(offset), 0); > +} > + > +static int lp87565_gpio_direction_output(struct gpio_chip *chip, > + unsigned int offset, int value) > +{ > + struct lp87565_gpio *gpio = gpiochip_get_data(chip); > + > + return regmap_update_bits(gpio->map, > + LP87565_REG_GPIO_CONFIG, > + BIT(offset), !value ? BIT(offset) : 0); > +} > + > +static int lp87565_gpio_get(struct gpio_chip *chip, unsigned int offset) > +{ > + struct lp87565_gpio *gpio = gpiochip_get_data(chip); > + int ret, val; > + > + ret = regmap_read(gpio->map, LP87565_REG_GPIO_IN, &val); > + if (ret < 0) > + return ret; > + > + return !!(val & BIT(offset)); > +} > + > +static void lp87565_gpio_set(struct gpio_chip *chip, unsigned int offset, > + int value) > +{ > + struct lp87565_gpio *gpio = gpiochip_get_data(chip); > + > + regmap_update_bits(gpio->map, LP87565_REG_GPIO_OUT, > + BIT(offset), value ? BIT(offset) : 0); > +} > + > +static int lp87565_gpio_request(struct gpio_chip *gc, unsigned int offset) > +{ > + struct lp87565_gpio *gpio = gpiochip_get_data(gc); > + int ret; > + > + switch (offset) { > + case 0: > + case 1: > + case 2: > + /* > + * MUX can program the pin to be in EN1/2/3 pin mode > + * Or GPIO1/2/3 mode. > + * Setup the GPIO*_SEL MUX to GPIO mode > + */ > + ret = regmap_update_bits(gpio->map, > + LP87565_REG_PIN_FUNCTION, > + BIT(offset), BIT(offset)); > + if (ret) > + return ret; > + > + break; > + default: > + return -EINVAL; > + } > + > + return 0; > +} > + > +static int lp87565_gpio_set_config(struct gpio_chip *gc, unsigned int offset, > + unsigned long config) > +{ > + struct lp87565_gpio *gpio = gpiochip_get_data(gc); > + > + switch (pinconf_to_config_param(config)) { > + case PIN_CONFIG_DRIVE_OPEN_DRAIN: > + return regmap_update_bits(gpio->map, > + LP87565_REG_GPIO_CONFIG, > + BIT(offset + > + __ffs(LP87565_GOIO1_OD)), > + BIT(offset + > + __ffs(LP87565_GOIO1_OD))); > + case PIN_CONFIG_DRIVE_PUSH_PULL: > + return regmap_update_bits(gpio->map, > + LP87565_REG_GPIO_CONFIG, > + BIT(offset + > + __ffs(LP87565_GOIO1_OD)), 0); > + default: > + return -ENOTSUPP; > + } > +} > + > +static const struct gpio_chip template_chip = { > + .label = "lp87565-gpio", > + .owner = THIS_MODULE, > + .request = lp87565_gpio_request, > + .get_direction = lp87565_gpio_get_direction, > + .direction_input = lp87565_gpio_direction_input, > + .direction_output = lp87565_gpio_direction_output, > + .get = lp87565_gpio_get, > + .set = lp87565_gpio_set, > + .set_config = lp87565_gpio_set_config, > + .base = -1, > + .ngpio = 3, > + .can_sleep = true, > +}; > + > +static int lp87565_gpio_probe(struct platform_device *pdev) > +{ > + struct lp87565_gpio *gpio; > + struct lp87565 *lp87565; > + int ret; > + > + gpio = devm_kzalloc(&pdev->dev, sizeof(*gpio), GFP_KERNEL); > + if (!gpio) > + return -ENOMEM; > + > + lp87565 = dev_get_drvdata(pdev->dev.parent); > + gpio->chip = template_chip; > + gpio->chip.parent = lp87565->dev; > + gpio->map = lp87565->regmap; > + > + ret = devm_gpiochip_add_data(&pdev->dev, &gpio->chip, gpio); > + if (ret < 0) { > + dev_err(&pdev->dev, "Could not register gpiochip, %d\n", ret); > + return ret; > + } > + > + return 0; > +} > + > +static const struct platform_device_id lp87565_gpio_id_table[] = { > + { "lp87565-q1-gpio", }, > + { /* sentinel */ } > +}; > +MODULE_DEVICE_TABLE(platform, lp87565_gpio_id_table); > + > +static struct platform_driver lp87565_gpio_driver = { > + .driver = { > + .name = "lp87565-gpio", > + }, > + .probe = lp87565_gpio_probe, > + .id_table = lp87565_gpio_id_table, > +}; > +module_platform_driver(lp87565_gpio_driver); > + > +MODULE_AUTHOR("Keerthy <j-keer...@ti.com>"); > +MODULE_DESCRIPTION("LP87565 GPIO driver"); > +MODULE_LICENSE("GPL v2"); >
