Hi all,
With the merge window opening, just a reminder that this conflict still
exists.
On Tue, 20 Jun 2017 13:52:42 +1000 Stephen Rothwell <s...@canb.auug.org.au>
wrote:
>
> Today's linux-next merge of the tty tree got a conflict in:
>
> include/linux/platform_data/atmel.h
>
> between commit:
>
> 8a3d809373c6 ("ARM: at91: remove atmel_nand_data")
>
> from the arm-soc tree and commit:
>
> 92c8f7c0e109 ("tty/serial: atmel: make the driver DT only")
>
> from the tty tree.
>
> I fixed it up (see below) and can carry the fix as necessary. This
> is now fixed as far as linux-next is concerned, but any non trivial
> conflicts should be mentioned to your upstream maintainer when your tree
> is submitted for merging. You may also want to consider cooperating
> with the maintainer of the conflicting tree to minimise any particularly
> complex conflicts.
>
> --
> Cheers,
> Stephen Rothwell
>
> diff --cc include/linux/platform_data/atmel.h
> index 70c5c766628e,d36bc8d17e97..000000000000
> --- a/include/linux/platform_data/atmel.h
> +++ b/include/linux/platform_data/atmel.h
> @@@ -7,8 -7,9 +7,6 @@@
> #ifndef __ATMEL_H__
> #define __ATMEL_H__
>
> - #include <linux/serial.h>
> -#include <linux/mtd/nand.h>
> -#include <linux/mtd/partitions.h>
> --
> /* Compact Flash */
> struct at91_cf_data {
> int irq_pin; /* I/O IRQ */
> @@@ -21,23 -22,26 +19,14 @@@
> #define AT91_IDE_SWAP_A0_A2 0x02
> };
>
> - /* Serial */
> - struct atmel_uart_data {
> - int num; /* port num */
> - short use_dma_tx; /* use transmit DMA? */
> - short use_dma_rx; /* use receive DMA? */
> - void __iomem *regs; /* virt. base address, if any */
> - struct serial_rs485 rs485; /* rs485 settings */
> - /* NAND / SmartMedia */
> -struct atmel_nand_data {
> - int enable_pin; /* chip enable */
> - int det_pin; /* card detect */
> - int rdy_pin; /* ready/busy */
> - u8 rdy_pin_active_low; /* rdy_pin value is inverted */
> - u8 ale; /* address line number
> connected to ALE */
> - u8 cle; /* address line number
> connected to CLE */
> - u8 bus_width_16; /* buswidth is 16 bit */
> - u8 ecc_mode; /* ecc mode */
> - u8 on_flash_bbt; /* bbt on flash */
> - struct mtd_partition *parts;
> - unsigned int num_parts;
> - bool has_dma; /* support dma transfer */
> -
> - /* default is false, only for at32ap7000 chip is true */
> - bool need_reset_workaround;
> --};
> --
> /* FIXME: this needs a better location, but gets stuff building again */
> +#ifdef CONFIG_ATMEL_PM
> extern int at91_suspend_entering_slow_clock(void);
> +#else
> +static inline int at91_suspend_entering_slow_clock(void)
> +{
> + return 0;
> +}
> +#endif
>
> #endif /* __ATMEL_H__ */
--
Cheers,
Stephen Rothwell
