>>>>> "John" == John Stoffel <[EMAIL PROTECTED]> writes:
>>> > Ok, so do I need to do anything special with the next -mm release and >>> > the next version? >>> >>> Well, let Alan decide that (2Alan: and I said that HPT code is bogus :-). Alan> Try drivers/ide/pci/hpt366 - if that works grab a dmesg and let Alan> me know. It means that Sergei's DPLL sync code seems to work Alan> better than the vendor code and its time to swap it over. John> Ok, I'll give that a whirl under 2.6.21-rc7 tonight. I'll build them John> in modular so I can switch around more easily. I hope. :] Ok, here's the dmesg output using the hpt366 old IDE driver, 2.6.21-rc7, SMP: [ 160.926355] HPT302: IDE controller at PCI slot 0000:03:06.0 [ 160.928030] ACPI: PCI Interrupt 0000:03:06.0[A] -> GSI 18 (level, low) -> IRQ 18 [ 160.931212] HPT302: chipset revision 1 [ 160.932801] HPT302: DPLL base: 66 MHz, f_CNT: 100, assuming 33 MHz PCI [ 160.941157] HPT302: using 66 MHz DPLL clock [ 160.942646] HPT302: 100% native mode on irq 18 [ 160.943918] ide2: BM-DMA at 0xe800-0xe807, BIOS settings: hde:DMA, hdf:pi o [ 160.946636] ide3: BM-DMA at 0xe808-0xe80f, BIOS settings: hdg:DMA, hdh:pi o [ 160.949439] Probing IDE interface ide2... [ 161.213560] hde: WDC WD1200JB-00CRA1, ATA DISK drive [ 161.828020] ide2 at 0xecf8-0xecff,0xecf2 on irq 18 [ 161.829616] Probing IDE interface ide3... [ 162.094086] hdg: WDC WD1200JB-00EVA0, ATA DISK drive [ 162.709002] ide3 at 0xece0-0xece7,0xecda on irq 18 Which looks ok to me I guess. It found my MD disks on there and assmebled them, eventually. *grin* I'll reboot and send out the corresponding ATA HPT37x driver dmesg... John - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
