Reading e1000e_check_for_copper_link() shows that get_link_status is set to
false after link has been detected. Therefore, it stays TRUE until then.
Signed-off-by: Benjamin Poirier <bpoir...@suse.com>
---
drivers/net/ethernet/intel/e1000e/netdev.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/intel/e1000e/netdev.c
b/drivers/net/ethernet/intel/e1000e/netdev.c
index 2dcb5463d9b8..58a87134d2e5 100644
--- a/drivers/net/ethernet/intel/e1000e/netdev.c
+++ b/drivers/net/ethernet/intel/e1000e/netdev.c
@@ -5074,7 +5074,7 @@ static bool e1000e_has_link(struct e1000_adapter *adapter)
/* get_link_status is set on LSC (link status) interrupt or
* Rx sequence error interrupt. get_link_status will stay
- * false until the check_for_link establishes link
+ * true until the check_for_link establishes link
* for copper adapters ONLY
*/
switch (hw->phy.media_type) {
@@ -5092,7 +5092,7 @@ static bool e1000e_has_link(struct e1000_adapter *adapter)
break;
case e1000_media_type_internal_serdes:
ret_val = hw->mac.ops.check_for_link(hw);
- link_active = adapter->hw.mac.serdes_has_link;
+ link_active = hw->mac.serdes_has_link;
break;
default:
case e1000_media_type_unknown:
--
2.13.2
