On 30/08/17 16:04, Ritesh Harjani wrote:
> There is a case when enabling the legacy IRQs and halting CQE is
> resuling into a command response interrupt without any command in
> progress. This patch handles such case here.
>
> Error signature without this patch:-
> mmc0: Got command interrupt 0x00000001 even though no command operation
> was in progress.
>
> Signed-off-by: Ritesh Harjani <rite...@codeaurora.org>
Seems fine, but this is a necessary part of enabling i.e. put all the
sdhci-msm changes into one patch.
> ---
> drivers/mmc/host/sdhci-msm.c | 11 +++++++++++
> 1 file changed, 11 insertions(+)
>
> diff --git a/drivers/mmc/host/sdhci-msm.c b/drivers/mmc/host/sdhci-msm.c
> index baa3409..8fdc2c0 100644
> --- a/drivers/mmc/host/sdhci-msm.c
> +++ b/drivers/mmc/host/sdhci-msm.c
> @@ -1124,10 +1124,21 @@ void sdhci_msm_cqe_enable(struct mmc_host *mmc)
> void sdhci_msm_cqe_disable(struct mmc_host *mmc, bool recovery)
> {
> struct sdhci_host *host = mmc_priv(mmc);
> + unsigned long flags;
> + u32 ctrl;
>
> if (host->flags & SDHCI_USE_64_BIT_DMA)
> host->desc_sz = 16;
>
> + spin_lock_irqsave(&host->lock, flags);
> +
Could use a comment here.
> + ctrl = sdhci_readl(host, SDHCI_INT_ENABLE);
> + ctrl |= SDHCI_INT_RESPONSE;
> + sdhci_writel(host, ctrl, SDHCI_INT_ENABLE);
> + sdhci_writel(host, SDHCI_INT_RESPONSE, SDHCI_INT_STATUS);
> +
> + spin_unlock_irqrestore(&host->lock, flags);
> +
> sdhci_cqe_disable(mmc, recovery);
> }
>
>
