[PATCH v2 2/2] ARM: dts: sun8i: h3: Improved Wifi bindings on Bananapi M2 Plus

[Philipp Rossak]

From: Philipp Rossak <embe...@gmail.com>

* vqmmc is in this case not needed
* no need for pincontrol nodes when the pin is set to a GPIO

Signed-off-by: Philipp Rossak <embe...@gmail.com>
---
 arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts | 7 -------
 1 file changed, 7 deletions(-)

diff --git a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts 
b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
index d756ff8..f7e5d8a 100644
--- a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
+++ b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
@@ -98,7 +98,6 @@
        wifi_pwrseq: wifi_pwrseq {
                compatible = "mmc-pwrseq-simple";
                pinctrl-names = "default";
-               pinctrl-0 = <&wifi_en_bpi_m2p>;
                reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */
        };
 };
@@ -153,7 +152,6 @@
        pinctrl-names = "default";
        pinctrl-0 = <&mmc1_pins_a>;
        vmmc-supply = <&reg_vcc3v3>;
-       vqmmc-supply = <&reg_vcc3v3>;
        mmc-pwrseq = <&wifi_pwrseq>;
        bus-width = <4>;
        non-removable;
@@ -200,11 +198,6 @@
                pins = "PL3";
                function = "gpio_in";
        };
-
-       wifi_en_bpi_m2p: wifi_en_pin {
-               pins = "PL7";
-               function = "gpio_out";
-       };
 };
 
 &reg_usb0_vbus {
-- 
2.7.4