On Sat, Sep 23, 2017 at 2:40 AM, Corentin Labbe
<clabbe.montj...@gmail.com> wrote:
> This patch fix the warning "xxx has a unit name, but no reg property" by
> removing "@0" from such node.
>
> Signed-off-by: Corentin Labbe <clabbe.montj...@gmail.com>
> Acked-by: Maxime Ripard <maxime.rip...@free-electrons.com>
> ---
> arch/arm/boot/dts/sunxi-h3-h5.dtsi | 12 ++++++------
> 1 file changed, 6 insertions(+), 6 deletions(-)
>
> diff --git a/arch/arm/boot/dts/sunxi-h3-h5.dtsi
> b/arch/arm/boot/dts/sunxi-h3-h5.dtsi
> index 289f2cd06dfe..2e4bae988acd 100644
> --- a/arch/arm/boot/dts/sunxi-h3-h5.dtsi
> +++ b/arch/arm/boot/dts/sunxi-h3-h5.dtsi
> @@ -322,7 +322,7 @@
> function = "i2c2";
> };
>
> - mmc0_pins_a: mmc0@0 {
> + mmc0_pins_a: mmc0 {
All pinmux nodes should have the suffix "_pins" or "_pin".
In the case where there are multiple choices, the node name should convey
what or which pingroup the choice is. In this case the name should be
"mmc0_pf_pins".
> pins = "PF0", "PF1", "PF2", "PF3",
> "PF4", "PF5";
> function = "mmc0";
> @@ -330,13 +330,13 @@
> bias-pull-up;
> };
>
> - mmc0_cd_pin: mmc0_cd_pin@0 {
> + mmc0_cd_pin: mmc0_cd_pin {
> pins = "PF6";
> function = "gpio_in";
> bias-pull-up;
> };
>
> - mmc1_pins_a: mmc1@0 {
> + mmc1_pins_a: mmc1 {
mmc1_pins
> pins = "PG0", "PG1", "PG2", "PG3",
> "PG4", "PG5";
> function = "mmc1";
> @@ -354,7 +354,7 @@
> bias-pull-up;
> };
>
> - spdif_tx_pins_a: spdif@0 {
> + spdif_tx_pins_a: spdif {
spdif_pin
> pins = "PA17";
> function = "spdif";
> };
> @@ -369,7 +369,7 @@
> function = "spi1";
> };
>
> - uart0_pins_a: uart0@0 {
> + uart0_pins_a: uart0 {
uart0_pb_pins
> pins = "PA4", "PA5";
> function = "uart0";
> };
> @@ -697,7 +697,7 @@
> interrupt-controller;
> #interrupt-cells = <3>;
>
> - ir_pins_a: ir@0 {
> + ir_pins_a: ir {
ir_pin
ChenYu
> pins = "PL11";
> function = "s_cir_rx";
> };
> --
> 2.13.5
>
