On 2017年11月07日 15:54, Vladimir Zapolskiy wrote:
Hello Chris,
On 11/07/2017 04:49 AM, Chris Zhong wrote:
The ethernet phy of rk3066a-rayeager has a reset pin, it controlled by
GPIO1_D6, this pin should be pull down then pull up to reset the phy.
Add a phy-reset property in emac, make the phy can be reset when emac
power on.
for PHY reset there are properties 'reset-gpios' and 'reset-delay-us',
please reference to Documentation/devicetree/bindings/net/mdio.txt
Can you try to reuse them instead of adding new custom properties?
This phy-reset is from Documentation/devicetree/bindings/net/arc_emac.txt.
And copy from arch/arm/boot/dts/rk3036-kylin.dts.
Can we just use these properties, they are not new.
As a side question, which is mainly addressed to Sergei and Roger,
I don't quite understand why PHY properties were initially added to
MAC/MDIO bus device tree nodes, in my opinion they must be moved under
PHY device tree nodes.
--
With best wishes,
Vladimir
Signed-off-by: Chris Zhong <z...@rock-chips.com>
---
arch/arm/boot/dts/rk3066a-rayeager.dts | 2 ++
1 file changed, 2 insertions(+)
diff --git a/arch/arm/boot/dts/rk3066a-rayeager.dts
b/arch/arm/boot/dts/rk3066a-rayeager.dts
index 570157f..6064a0a 100644
--- a/arch/arm/boot/dts/rk3066a-rayeager.dts
+++ b/arch/arm/boot/dts/rk3066a-rayeager.dts
@@ -173,6 +173,8 @@
pinctrl-0 = <&emac_xfer>, <&emac_mdio>, <&rmii_rst>;
phy = <&phy0>;
phy-supply = <&vcc_rmii>;
+ phy-reset-gpios = <&gpio1 RK_PD6 GPIO_ACTIVE_LOW>; /* PHY_RST */
+ phy-reset-duration = <10>; /* millisecond */
status = "okay";
phy0: ethernet-phy@0 {
--
Chris Zhong
