imx25 contains two registers (LPIMR0 and 1) to define which interrupts are enabled in low-power mode. As of today, those two registers are configured to enable all interrupts. Before going to low-power mode, the AVIC's INTENABLEH and INTENABLEL registers are configured to enable only those interrupts which are used as wakeup sources.
It turned out that this approach is not sufficient if we want the imx25 to go into stop mode during suspend-to-ram. (Stop mode is the low-power mode that consumes the least power. The peripheral master clock is switched off in this mode). For stop mode to work, the LPIMR0 and 1 registers have to be configured with the set of interrupts that are allowed in low-power mode. Fortunately, the bits in the LPIMR registers are assigned to the same interrups as the bits in INTENABLEH and INTENABLEL. However, LPIMR uses 1 to mask an interrupt whereas the INTENABLE registers use 1 to enable an interrupt. This patch sets the LPIMR registers to the inverted bitmask of the INTENABLE registers during suspend and goes back to "all interrupts masked" when we wake up again. We also make this the default at startup. As far as I know, the other supported imx architectures have no similar mechanism. Since the LPIMR registers are part of the CCM module, we query the device tree for an imx25 ccm node in order to detect if we're running on imx25. Signed-off-by: Martin Kaiser <mar...@kaiser.cx> --- Dear all, could you have a look at this first draft? The approach to detect imx25 looks a bit hackish, I'd appreciate your suggestions how to do this properly. Thanks & best regards, Martin arch/arm/mach-imx/avic.c | 24 +++++++++++++++++++++++- 1 file changed, 23 insertions(+), 1 deletion(-) diff --git a/arch/arm/mach-imx/avic.c b/arch/arm/mach-imx/avic.c index 1afccae..bd6d3f2 100644 --- a/arch/arm/mach-imx/avic.c +++ b/arch/arm/mach-imx/avic.c @@ -22,6 +22,7 @@ #include <linux/irqdomain.h> #include <linux/io.h> #include <linux/of.h> +#include <linux/of_address.h> #include <asm/mach/irq.h> #include <asm/exception.h> @@ -51,7 +52,10 @@ #define AVIC_NUM_IRQS 64 -static void __iomem *avic_base; +#define MX25_CCM_LPIMR0 0x68 +#define MX25_CCM_LPIMR1 0x6C + +static void __iomem *avic_base, *mx25_ccm_base; static struct irq_domain *domain; #ifdef CONFIG_FIQ @@ -93,6 +97,11 @@ static void avic_irq_suspend(struct irq_data *d) avic_saved_mask_reg[idx] = imx_readl(avic_base + ct->regs.mask); imx_writel(gc->wake_active, avic_base + ct->regs.mask); + if (mx25_ccm_base) { + u8 offs = d->hwirq < AVIC_NUM_IRQS / 2 ? + MX25_CCM_LPIMR0 : MX25_CCM_LPIMR1; + imx_writel(~gc->wake_active, mx25_ccm_base + offs); + } } static void avic_irq_resume(struct irq_data *d) @@ -102,6 +111,11 @@ static void avic_irq_resume(struct irq_data *d) int idx = d->hwirq >> 5; imx_writel(avic_saved_mask_reg[idx], avic_base + ct->regs.mask); + if (mx25_ccm_base) { + u8 offs = d->hwirq < AVIC_NUM_IRQS / 2 ? + MX25_CCM_LPIMR0 : MX25_CCM_LPIMR1; + imx_writel(0xffffffff, mx25_ccm_base + offs); + } } #else @@ -158,6 +172,14 @@ void __init mxc_init_irq(void __iomem *irqbase) avic_base = irqbase; + np = of_find_compatible_node(NULL, NULL, "fsl,imx25-ccm"); + mx25_ccm_base = of_iomap(np, 0); + + if (mx25_ccm_base) { + imx_writel(0xffffffff, mx25_ccm_base + MX25_CCM_LPIMR0); + imx_writel(0xffffffff, mx25_ccm_base + MX25_CCM_LPIMR1); + } + /* put the AVIC into the reset value with * all interrupts disabled */ -- 2.1.4