Tested on Centriq 2400

Reviewed-by: Austin Christ <[email protected]>

On 2/3/2018 12:58 AM, Abhishek Sahu wrote:
Currently each message length in complete transfer is being
checked for determining DMA mode and if any of the message length
is less than FIFO length then non DMA mode is being used which
will increase overhead. DMA can be used for any length and it
should be determined with complete transfer length. Now, this
patch introduces DMA threshold length and the transfer will be
done in DMA mode if the total length is greater than this
threshold length.

Signed-off-by: Abhishek Sahu <[email protected]>
---
  drivers/i2c/busses/i2c-qup.c | 15 +++++++++------
  1 file changed, 9 insertions(+), 6 deletions(-)

diff --git a/drivers/i2c/busses/i2c-qup.c b/drivers/i2c/busses/i2c-qup.c
index 6227a5c..a91fc70 100644
--- a/drivers/i2c/busses/i2c-qup.c
+++ b/drivers/i2c/busses/i2c-qup.c
@@ -192,6 +192,8 @@ struct qup_i2c_dev {
        bool                    is_dma;
        /* To check if the current transfer is using DMA */
        bool                    use_dma;
+       /* The threshold length above which DMA will be used */
+       unsigned int            dma_threshold;
        struct                  dma_pool *dpool;
        struct                  qup_i2c_tag start_tag;
        struct                  qup_i2c_bam brx;
@@ -1294,7 +1296,8 @@ static int qup_i2c_xfer_v2(struct i2c_adapter *adap,
                           int num)
  {
        struct qup_i2c_dev *qup = i2c_get_adapdata(adap);
-       int ret, len, idx = 0;
+       int ret, idx = 0;
+       unsigned int total_len = 0;
qup->bus_err = 0;
        qup->qup_err = 0;
@@ -1320,14 +1323,13 @@ static int qup_i2c_xfer_v2(struct i2c_adapter *adap,
                                goto out;
                        }
- len = (msgs[idx].len > qup->out_fifo_sz) ||
-                             (msgs[idx].len > qup->in_fifo_sz);
-
-                       if (is_vmalloc_addr(msgs[idx].buf) || !len)
+                       if (is_vmalloc_addr(msgs[idx].buf))
                                break;
+
+                       total_len += msgs[idx].len;
                }
- if (idx == num)
+               if (idx == num && total_len > qup->dma_threshold)
                        qup->use_dma = true;
        }
@@ -1587,6 +1589,7 @@ static int qup_i2c_probe(struct platform_device *pdev) size = QUP_INPUT_FIFO_SIZE(io_mode);
        qup->in_fifo_sz = qup->in_blk_sz * (2 << size);
+       qup->dma_threshold = min(qup->out_fifo_sz, qup->in_fifo_sz);
fs_div = ((src_clk_freq / clk_freq) / 2) - 3;
        hs_div = 3;


--
Qualcomm Datacenter Technologies as an affiliate of Qualcomm Technologies, Inc.
Qualcomm Technologies, Inc. is a member of the
Code Aurora Forum, a Linux Foundation Collaborative Project.

Reply via email to