On Fri, Mar 09, 2018 at 03:58:20PM -0600, Eddie James wrote:
> From: Milton Miller <milt...@us.ibm.com>
>
> Allow the device tree to specify a watchdog to fallover to
> the alternate boot source.
>
> The aspeeed watchdog can set a latch directing flash chip select 0 to
> chip select 1, allowing boot from an alternate media if the watchdog
> is not reset in time. On the ast2400 bank 1 also goes to flash bank 1,
> while on the ast2500 the chip selects are swapped.
>
> Signed-off-by: Milton Miller <milt...@us.ibm.com>
> Signed-off-by: Eddie James <eaja...@linux.vnet.ibm.com>
This is already documented in the bindings document, so the property
should be ok.
Reviewed-by: Guenter Roeck <li...@roeck-us.net>
> ---
> drivers/watchdog/aspeed_wdt.c | 3 +++
> 1 file changed, 3 insertions(+)
>
> diff --git a/drivers/watchdog/aspeed_wdt.c b/drivers/watchdog/aspeed_wdt.c
> index d1987d6..f41d246 100644
> --- a/drivers/watchdog/aspeed_wdt.c
> +++ b/drivers/watchdog/aspeed_wdt.c
> @@ -46,6 +46,7 @@ struct aspeed_wdt_config {
> #define WDT_RELOAD_VALUE 0x04
> #define WDT_RESTART 0x08
> #define WDT_CTRL 0x0C
> +#define WDT_CTRL_BOOT_SECONDARY BIT(7)
> #define WDT_CTRL_RESET_MODE_SOC (0x00 << 5)
> #define WDT_CTRL_RESET_MODE_FULL_CHIP (0x01 << 5)
> #define WDT_CTRL_RESET_MODE_ARM_CPU (0x10 << 5)
> @@ -245,6 +246,8 @@ static int aspeed_wdt_probe(struct platform_device *pdev)
> }
> if (of_property_read_bool(np, "aspeed,external-signal"))
> wdt->ctrl |= WDT_CTRL_WDT_EXT;
> + if (of_property_read_bool(np, "aspeed,alt-boot"))
> + wdt->ctrl |= WDT_CTRL_BOOT_SECONDARY;
>
> if (readl(wdt->base + WDT_CTRL) & WDT_CTRL_ENABLE) {
> /*
> --
> 1.8.3.1
>
