On Fri, Mar 30, 2018 at 12:26:43AM +0300, Ilia Lin wrote: > Add support for SAW controlled regulators in 8x96. > Document it.
Perhaps some clue in the subject what subsystem and/or device this applies to. > > Signed-off-by: Ilia Lin <[email protected]> > --- > .../bindings/regulator/qcom,spmi-regulator.txt | 45 > ++++++++++++++++++++++ > 1 file changed, 45 insertions(+) > > diff --git > a/Documentation/devicetree/bindings/regulator/qcom,spmi-regulator.txt > b/Documentation/devicetree/bindings/regulator/qcom,spmi-regulator.txt > index 57d2c65..406f2e5 100644 > --- a/Documentation/devicetree/bindings/regulator/qcom,spmi-regulator.txt > +++ b/Documentation/devicetree/bindings/regulator/qcom,spmi-regulator.txt > @@ -110,6 +110,11 @@ Qualcomm SPMI Regulators > Definition: Reference to regulator supplying the input pin, as > described in the data sheet. > > +- qcom,saw-reg: > + Usage: optional > + Value type: <phandle> > + Description: Reference to syscon node defining the SAW registers. > + > > The regulator node houses sub-nodes for each regulator within the device. > Each > sub-node is identified using the node's name, with valid values listed for > each > @@ -201,6 +206,17 @@ see regulator.txt - with additional custom properties > described below: > 2 = 0.55 uA > 3 = 0.75 uA > > +- qcom,saw-slave: > + Usage: optional > + Value type: <boo> > + Description: SAW controlled gang slave. Will not be configured. > + > +- qcom,saw-leader: > + Usage: optional > + Value type: <boo> > + Description: SAW controlled gang leader. Will be configured as > + SAW regulator. Would the coupled regulator binding work in this case? Rob
