On Wed, Jun 06, 2007 at 10:16:14PM +0200, Filippo Carletti wrote: > >>> The original patch contained also this lines (that I omitted): > >>> + /* JMicron-specific fixup: make sure we're in AHCI mode */ > >>> + if (pdev->vendor == 0x197b) > >>> + pci_write_config_byte(pdev, 0x41, 0xa1); > >> NAK. Don't omit obviously needed lines, if you are going to add JMicron > >> PCI IDs. > > > > Filippo, > > > > would you please resend your patch including the lines you have omitted ? > > Jeff is right, those lines are explicitly labelled as a fixup, so either > > we merge the complete patch, or nothing at all. > > I'm attaching a revised patch that includes JMicron fixup I missed earlier.
Thanks for your quick reply Filippo. > The patch applies but it's not tested because I lack appropriate hw. Just for information, have you built it already ? Jeff, does this one look good to you ? Thanks, Willy > --- drivers/scsi/ahci.c.orig 2006-12-23 20:34:20.000000000 +0000 > +++ drivers/scsi/ahci.c 2007-05-11 22:11:52.000000000 +0000 > @@ -275,6 +275,24 @@ > board_ahci }, /* ESB2 */ > { PCI_VENDOR_ID_INTEL, 0x27c6, PCI_ANY_ID, PCI_ANY_ID, 0, 0, > board_ahci }, /* ICH7-M DH */ > + { PCI_VENDOR_ID_INTEL, 0x2821, PCI_ANY_ID, PCI_ANY_ID, 0, 0, > + board_ahci }, /* ICH8 */ > + { PCI_VENDOR_ID_INTEL, 0x2822, PCI_ANY_ID, PCI_ANY_ID, 0, 0, > + board_ahci }, /* ICH8 */ > + { PCI_VENDOR_ID_INTEL, 0x2824, PCI_ANY_ID, PCI_ANY_ID, 0, 0, > + board_ahci }, /* ICH8 */ > + { PCI_VENDOR_ID_INTEL, 0x2829, PCI_ANY_ID, PCI_ANY_ID, 0, 0, > + board_ahci }, /* ICH8M */ > + { PCI_VENDOR_ID_INTEL, 0x282a, PCI_ANY_ID, PCI_ANY_ID, 0, 0, > + board_ahci }, /* ICH8M */ > + { 0x197b, 0x2360, PCI_ANY_ID, PCI_ANY_ID, 0, 0, > + board_ahci }, /* JMicron JMB360 */ > + { 0x197b, 0x2363, PCI_ANY_ID, PCI_ANY_ID, 0, 0, > + board_ahci }, /* JMicron JMB363 */ > + { PCI_VENDOR_ID_ATI, 0x4380, PCI_ANY_ID, PCI_ANY_ID, 0, 0, > + board_ahci }, /* ATI SB600 non-raid */ > + { PCI_VENDOR_ID_ATI, 0x4381, PCI_ANY_ID, PCI_ANY_ID, 0, 0, > + board_ahci }, /* ATI SB600 raid */ > { } /* terminate list */ > }; > > @@ -1085,6 +1085,10 @@ > if (have_msi) > hpriv->flags |= AHCI_FLAG_MSI; > > + /* JMicron-specific fixup: make sure we're in AHCI mode */ > + if (pdev->vendor == 0x197b) > + pci_write_config_byte(pdev, 0x41, 0xa1); > + > /* initialize adapter */ > rc = ahci_host_init(probe_ent); > if (rc) - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/