On 25 April 2018 at 05:10, Shunyong Yang <[email protected]> wrote:
> It means firmware attempts to immediately process or launch the capsule
> when flags in capsule header is not set. Moreover, reset is not needed
> in this case. Current code will output log to indicate reset.
>
> This patch adds a branch to avoid reset log output when the flags is not
> set.
>
> Cc: Joey Zheng <[email protected]>
> Signed-off-by: Shunyong Yang <[email protected]>
> ---
> drivers/firmware/efi/capsule-loader.c | 13 +++++++++----
> 1 file changed, 9 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/firmware/efi/capsule-loader.c
> b/drivers/firmware/efi/capsule-loader.c
> index e456f4602df1..a63b8e5bde23 100644
> --- a/drivers/firmware/efi/capsule-loader.c
> +++ b/drivers/firmware/efi/capsule-loader.c
> @@ -134,10 +134,15 @@ static ssize_t efi_capsule_submit_update(struct
> capsule_info *cap_info)
>
> /* Indicate capsule binary uploading is done */
> cap_info->index = NO_FURTHER_WRITE_ACTION;
> - pr_info("Successfully upload capsule file with reboot type '%s'\n",
> - !cap_info->reset_type ? "RESET_COLD" :
> - cap_info->reset_type == 1 ? "RESET_WARM" :
> - "RESET_SHUTDOWN");
> +
> + if (cap_info->header.flags)
You should check for the relevant flag bits here, because the 16 lower
bits are platform dependent.
> + pr_info("Successfully upload capsule file with reboot type
> '%s'\n",
> + !cap_info->reset_type ? "RESET_COLD" :
> + cap_info->reset_type == 1 ? "RESET_WARM" :
> + "RESET_SHUTDOWN");
> + else
> + pr_info("Successfully upload, process and launch capsule
> file\n");
> +
> return 0;
> }
>
> --
> 1.8.3.1
>
