On 6/13/2018 1:36 AM, Grygorii Strashko wrote:
On 06/12/2018 02:59 AM, Keerthy wrote:
Currently the driver assumes that the interrupts are continuous
and does platform_get_irq only once and assumes the rest are continuous,
instead call platform_get_irq for all the interrupts and store them
in an array for later use.
Signed-off-by: Keerthy <j-keer...@ti.com>
---
Tested for GPIO Interrupts on da850-lcdk board.
Changes in v3:
* Changed irqs type from unsigned to int
Changes in v2:
* Extended the logic of using saved IRQs to unbanked IRQs
as per Grygorii's suggestion.
drivers/gpio/gpio-davinci.c | 54
+++++++++++++++++++-----------
include/linux/platform_data/gpio-davinci.h | 3 +-
2 files changed, 36 insertions(+), 21 deletions(-)
[...]
@@ -383,7 +396,7 @@ static int gpio_to_irq_unbanked(struct gpio_chip *chip, unsigned offset)
* can provide direct-mapped IRQs to AINTC (up to 32 GPIOs).
*/
if (offset < d->gpio_unbanked)
- return d->base_irq + offset;
+ return d->irqs[offset];
this one seems right
else
return -ENODEV;
}
@@ -396,7 +409,7 @@ static int gpio_irq_type_unbanked(struct irq_data *data,
unsigned trigger)
d = (struct davinci_gpio_controller *)irq_data_get_irq_handler_data(data);
g = (struct davinci_gpio_regs __iomem *)d->regs[0];
- mask = __gpio_mask(data->irq - d->base_irq);
+ mask = __gpio_mask(data->irq - d->irqs[0]);
but this one is not. You can't do "base + offset" or "irq - base" ops
if Irqs range is not sequential. So, in my opinion, here you need to
convert irq to gpio bank offset (hwirq value in irq_data is not offset
- gic specific value) which means - walk through d->irqs[x] and find
item with d->irqs[x] == irq which will give gpio bank offset.
Than offset can be used to build mask.
Agreed.
if (trigger & ~(IRQ_TYPE_EDGE_FALLING | IRQ_TYPE_EDGE_RISING))
return -EINVAL;
@@ -458,7 +471,7 @@ static struct irq_chip *keystone_gpio_get_irq_chip(unsigned
int irq)
* (dm6446) can be set appropriately for GPIOV33 pins.
*/
-static int davinci_gpio_irq_setup(struct platform_device *pdev, int bank_irq)
[...]
#include <asm-generic/gpio.h>
#define MAX_REGS_BANKS 5
+#define MAX_INT_PER_BANK 32
struct davinci_gpio_platform_data {
u32 ngpio;
@@ -41,7 +42,7 @@ struct davinci_gpio_controller {
spinlock_t lock;
void __iomem *regs[MAX_REGS_BANKS];
int gpio_unbanked;
- unsigned int base_irq;
+ int irqs[MAX_INT_PER_BANK];
unsigned int base;
};
