This series adds an algorithm for an I2C master physically located on an FSI
slave device. The I2C master has multiple ports, each of which may be connected
to an I2C slave. Access to the I2C master registers is achieved over FSI bus.
Due to the multi-port nature of the I2C master, the driver instantiates a new
I2C adapter for each port connected to a slave. The connected ports should be
defined in the device tree under the I2C master device.
Changes since v11
- Remove I2C_FUNC_10BIT_ADDR since we don't support it
- Don't shift the msg->addr when encoding the command; use it as-is
Changes since v10
- Add myself to maintainers
- Rework the reset path. Use generic bus recovery and only do the reset if SDA
is low.
- Fixed email signature on dts patch
- Pulled in Ben H's fix for use-after-free in remove()
Changes since v9
- Switch the status masks to use a combination of bits rather than directly
coding the value
- Remove the interrupt mask definition as it was unused
- Fixed return value of master_xfer function (return number of xfrs, not 0)
Changes since v8
- Drop unecessary else statements
- Use i++ instead of ++i
- Use kzalloc/kfree instead of devm_kzalloc/devm_kfree for port structure
- Drop the list_empty check in remove
Changes since v7
- Fix grammer in Kconfig (a -> an)
- Change I2C registers to use BIT and GENMASK
- Remove custom macros and use FIELD_PREP and FIELD_GET
- Fix a few unecessary initializations and "return rc" that are always zero
- Clean up the read/write fifo functions a bit
- Few other clean-up items
Changes since v6
- Remove spinlock for reset functionality; it's unecessary and doesn't work
with the latest FSI core.
- Use a mutex instead of a semaphore, and don't wait for timeout to get the
lock.
- Use usleeps instead of schedule_timeout; it's not worth the overhead when
the wait should be very short in between sending the command and receiving
the response.
Changes since v5
- Fix reset functionality and do a reset after every transfer failure
eaja...@linux.vnet.ibm.com (8):
dt-bindings: i2c: Add FSI-attached I2C master dt binding documentation
i2c: Add FSI-attached I2C master algorithm
i2c: fsi: Add port structures
i2c: fsi: Add abort and hardware reset procedures
i2c: fsi: Add transfer implementation
i2c: fsi: Add I2C master locking
i2c: fsi: Add bus recovery
MAINTAINERS: Add Eddie as the maintainer for the FSI-attached I2C
driver
Documentation/devicetree/bindings/i2c/i2c-fsi.txt | 40 ++
MAINTAINERS | 8 +
drivers/i2c/busses/Kconfig | 11 +
drivers/i2c/busses/Makefile | 1 +
drivers/i2c/busses/i2c-fsi.c | 752 ++++++++++++++++++++++
5 files changed, 812 insertions(+)
create mode 100644 Documentation/devicetree/bindings/i2c/i2c-fsi.txt
create mode 100644 drivers/i2c/busses/i2c-fsi.c
--
1.8.3.1
