Hi Matthias,

On 2018-07-23 23:26, Matthias Kaehlcke wrote:
On Fri, Jul 20, 2018 at 07:02:40PM +0530, Balakrishna Godavarthi wrote:
In function qca_setup, we set initial and operating speeds for Qualcomm
Bluetooth SoC's. This block of code is common across different
Qualcomm Bluetooth SoC's. Instead of duplicating the code, created
a wrapper function to set the speeds. So that future coming SoC's
can use these wrapper functions to set speeds.

Signed-off-by: Balakrishna Godavarthi <bgoda...@codeaurora.org>
Reviewed-by: Matthias Kaehlcke <m...@chromium.org>
---
drivers/bluetooth/hci_qca.c | 93 ++++++++++++++++++++++++++++---------
 1 file changed, 70 insertions(+), 23 deletions(-)

diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index 5f1c0a8fd5cd..5f8a74d65bec 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -119,6 +119,11 @@ struct qca_data {
        u64 votes_off;
 };

+enum qca_speed_type {
+       QCA_INIT_SPEED = 1,
+       QCA_OPER_SPEED
+};
+
 struct qca_serdev {
        struct hci_uart  serdev_hu;
        struct gpio_desc *bt_en;
@@ -923,6 +928,61 @@ static inline void host_set_baudrate(struct hci_uart *hu, unsigned int speed)
                hci_uart_set_baudrate(hu, speed);
 }

+static unsigned int qca_get_speed(struct hci_uart *hu,
+                                 enum qca_speed_type speed_type)
+{
+       unsigned int speed = 0;
+
+       if (speed_type == QCA_INIT_SPEED) {
+               if (hu->init_speed)
+                       speed = hu->init_speed;
+               else if (hu->proto->init_speed)
+                       speed = hu->proto->init_speed;
+       } else {
+               if (hu->oper_speed)
+                       speed = hu->oper_speed;
+               else if (hu->proto->oper_speed)
+                       speed = hu->proto->oper_speed;
+       }
+
+       return speed;
+}
+
+static int qca_check_speeds(struct hci_uart *hu)
+{
+       if (!qca_get_speed(hu, QCA_INIT_SPEED) ||
+           !qca_get_speed(hu, QCA_OPER_SPEED))
+               return -EINVAL;

You changed this from:

        /* One or the other speeds should be non zero. */
        if (!qca_get_speed(hu, QCA_INIT_SPEED) &&
            !qca_get_speed(hu, QCA_OPER_SPEED))
                return -EINVAL;

There is no entry in the change log. What is the reason for this
change?

[Bala] : My bad i missed to add the log,as the above if for ROME chip, having INIT or OPER speed is fine.

--
Regards
Balakrishna.

Reply via email to