On Wed, Aug 01, 2018 at 07:31:53PM +0300, Aapo Vienamo wrote: > Add bindings documentation for pad pull up and pull down offset values to be > programmed before executing automatic pad drive strength calibration. > > Signed-off-by: Aapo Vienamo <[email protected]> > --- > .../bindings/mmc/nvidia,tegra20-sdhci.txt | 36 > ++++++++++++++++++++++ > 1 file changed, 36 insertions(+) > > diff --git a/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt > b/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt > index 90c214d..2e973b5 100644 > --- a/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt > +++ b/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt > @@ -24,6 +24,7 @@ Required properties: > Optional properties: > - power-gpios : Specify GPIOs for power control > > +Optional properties for Tegra210 and Tegra186:
This looks like a stray addition.
> Example:
>
> sdhci@c8000200 {
> @@ -45,6 +46,37 @@ Optional properties for Tegra210 and Tegra186:
> for controllers supporting multiple voltage levels. The order of names
> should correspond to the pin configuration states in pinctrl-0 and
> pinctrl-1.
> +- nvidia,only-1-8-v : The presence of this property indicates that the
> + controller operates at a 1.8 V fixed I/O voltage.
> +- nvidia,pad-autocal-pull-up-offset-3v3,
> + nvidia,pad-autocal-pull-down-offset-3v3 : Specify drive strength
> + calibration offsets for 3.3 V signaling modes.
> +- nvidia,pad-autocal-pull-up-offset-1v8,
> + nvidia,pad-autocal-pull-down-offset-1v8 : Specify drive strength
> + calibration offsets for 1.8 V signaling modes.
> +- nvidia,pad-autocal-pull-up-offset-3v3-timeout,
> + nvidia,pad-autocal-pull-down-offset-3v3-timeout : Specify drive
> + strength used as a fallback in case the automatic calibration times
> + out on a 3.3 V signaling mode.
> +- nvidia,pad-autocal-pull-up-offset-1v8-timeout,
> + nvidia,pad-autocal-pull-down-offset-1v8-timeout : Specify drive
> + strength used as a fallback in case the automatic calibration times
> + out on a 1.8 V signaling mode.
> +- nvidia,pad-autocal-pull-up-offset-sdr104,
> + nvidia,pad-autocal-pull-down-offset-sdr104 : Specify drive strength
> + calibration offsets for SDR104 mode.
> +- nvidia,pad-autocal-pull-up-offset-hs400,
> + nvidia,pad-autocal-pull-down-offset-hs400 : Specify drive strength
> + calibration offsets for HS400 mode.
There's no mention here about how many values each of these properties
needs. I guess given that the property names are singular it implies a
single value.
Thierry
signature.asc
Description: PGP signature
