Hi Arnd,
On 14-08-18 00:04, Arnd Bergmann wrote:
When CONFIG_BT_HCIUART_RTL is disabled, the hci_h5 driver produces a build
warning because of an incorrect set of #ifdef guards:
drivers/bluetooth/hci_h5.c:920:22: error: 'rtl_vnd' defined but not used
[-Werror=unused-variable]
Replacing the #ifdef with an IS_ENABLED() check shuts up the error
and simplifies the logic.
Signed-off-by: Arnd Bergmann <a...@arndb.de>
Hmm, so now you're counting on dead code elimination to remove
references to unavailable symbols. I'm not sure I like this and
since Marcel has also indicated the does not like this fix I
believe we need another fix.
I will write another fix for this.
Regards,
Hans
---
drivers/bluetooth/hci_h5.c | 10 +++-------
1 file changed, 3 insertions(+), 7 deletions(-)
diff --git a/drivers/bluetooth/hci_h5.c b/drivers/bluetooth/hci_h5.c
index 8eede1197cd2..b10e64ba0ff4 100644
--- a/drivers/bluetooth/hci_h5.c
+++ b/drivers/bluetooth/hci_h5.c
@@ -841,7 +841,6 @@ static void h5_serdev_remove(struct serdev_device *serdev)
hci_uart_unregister_device(&h5->serdev_hu);
}
-#ifdef CONFIG_BT_HCIUART_RTL
static int h5_btrtl_setup(struct h5 *h5)
{
struct btrtl_device_info *btrtl_dev;
@@ -923,24 +922,21 @@ static struct h5_vnd rtl_vnd = {
.close = h5_btrtl_close,
.acpi_gpio_map = acpi_btrtl_gpios,
};
-#endif
-#ifdef CONFIG_ACPI
static const struct acpi_device_id h5_acpi_match[] = {
-#ifdef CONFIG_BT_HCIUART_RTL
{ "OBDA8723", (kernel_ulong_t)&rtl_vnd },
-#endif
{ },
};
MODULE_DEVICE_TABLE(acpi, h5_acpi_match);
-#endif
static struct serdev_device_driver h5_serdev_driver = {
.probe = h5_serdev_probe,
.remove = h5_serdev_remove,
.driver = {
.name = "hci_uart_h5",
- .acpi_match_table = ACPI_PTR(h5_acpi_match),
+ .acpi_match_table = (IS_ENABLED(CONFIG_BT_HCIUART_RTL) &&
+ IS_ENABLED(CONFIG_ACPI)) ?
+ h5_acpi_match : 0,
},
};