On Fri, 2018-08-17 at 14:12 +0800, Hanjie Lin wrote: > > On 2018/8/16 16:33, Jerome Brunet wrote: > > On Thu, 2018-08-16 at 11:05 +0800, Hanjie Lin wrote: > > > > > > On 2018/8/14 18:41, Jerome Brunet wrote: > > > > On Tue, 2018-08-14 at 02:12 -0400, Hanjie Lin wrote: > > > > > From: Yue Wang <yue.w...@amlogic.com> > > > > > > > > > > The Meson-PCIE-PHY controller supports the 5-Gbps data rate > > > > > of the PCI Express Gen 2 specification and is backwardcompatible > > > > > with the 2.5-Gbps Gen 1.1 specification with only > > > > > inferred idle detection supported on AMLOGIC SoCs. > > > > > > > > It looks like the sole purpose of this driver is to provide the reset > > > > lines to > > > > pcie driver. > > > > > > > > I wonder why we need this ? Can't the pcie driver claim the reset lines > > > > itself. > > > > > > > > Also, an init of this phy will always reset both port. What will happen > > > > if the > > > > first port is in use and the 2nd port comes up ?? > > > > > > > > Looks the the pcie driver should claim 'apb' and 'phy' reset lines as > > > > "shared" > > > > reset and the required 'port' as 'exclusive' > > > > > > > > > > Thank you for your response. > > > > > > Yes, 'apb' and 'phy' reset lines are shared, and ‘port' reset line is > > > exclusive. > > > If we handle all reset lines during the first port initial sequence, > > > and when the second port comes up, we will do nothing about the rest > > > lines, > > > and don't need a extra API to do ‘port' reset; > > > > With which other driver are your control shared ? > > > > Looks it is the answer is none since this phy driver will reset both port > > already, even if one is used. > > > > In this case the fact that you are using shared control is just abusing the > > framework to reset once. > > > > As far as I can tell, this driver makes no sense. The appropriate reset > > lines > > should be given directly to your pcie driver. > > > > > > > > . > > > > Amlogic AXG SOC includes two pcie controllers and pipes when only one pcie > phy: > > (port_a reset) > |PCIE_RC_A---->PCIE_PIPE_A------| > (apb_reset) | | (phy reset) > APB BUS---> | | PCIE_PHY > | | > | (port_b_reset) | > |PCIE_RC_B---->PCIE_PIPE_B------| > > The phy_reset affect the PCIE_PHY. > The port_a_reset affect the PCIE_PIPE_A, port_b_reset affect the PCIE_PIPE_B. > > As your suggestion we will move the 'port' reset to controller driver, > and keeping the phy driver to process the 'apb' and 'phy' reset or any > more changes of the phy in future.
As far as I can tell from this diagram, It would only make sense for the "phy" reset line to be controlled by your phy driver. The apb and port is obviously related to the pcie device/driver itself, not the PHY. And whether you 1 or 2 reset lines in it, IMO it is overkill and unnecessary to make a phy driver for this. >