Hi Lina,
On Fri, Aug 24, 2018 at 02:01:53PM -0600, Lina Iyer wrote:
> QCOM SoC's that have Power Domain Controller (PDC) chip in the always-on
> domain can wakeup the SoC, when interrupts and GPIOs are routed to the
> its interrupt controller. Only select GPIOs that are deemed wakeup
wording nit: "are routed to the|its interrupt controller"
> capable are routed to specific PDC pins. During low power state, the
> pinmux interrupt controller may be non-functional but the PDC would be.
> The PDC can detect the wakeup GPIO is triggered and bring the TLMM to an
> operational state.
>
> Interrupts that are level triggered will be detected at the TLMM when
> the controller becomes operational. Edge interrupts however need to be
> replayed again.
>
> Request the corresponding PDC IRQ, when the GPIO is requested as an IRQ,
> but keep it disabled. During suspend, we can enable the PDC IRQ instead
> of the GPIO IRQ, which may or not be detected.
>
> Signed-off-by: Lina Iyer <il...@codeaurora.org>
> ---
> Changes in v2:
> - Remove IRQF_NO_SUSPEND and IRQF_ONE_SHOT from PDC IRQ
> Changes in v1:
> - Trigger GPIO in h/w from PDC IRQ handler
> - Avoid big tables for GPIO-PDC map, pick from DT instead
> - Use handler_data
> ---
> drivers/pinctrl/qcom/pinctrl-msm.c | 96 ++++++++++++++++++++++++++++++
> 1 file changed, 96 insertions(+)
>
> diff --git a/drivers/pinctrl/qcom/pinctrl-msm.c
> b/drivers/pinctrl/qcom/pinctrl-msm.c
> index 0e22f52b2a19..b675ea56a4ff 100644
> --- a/drivers/pinctrl/qcom/pinctrl-msm.c
> +++ b/drivers/pinctrl/qcom/pinctrl-msm.c
> @@ -687,11 +687,15 @@ static int msm_gpio_irq_set_type(struct irq_data *d,
> unsigned int type)
> const struct msm_pingroup *g;
> unsigned long flags;
> u32 val;
> + struct irq_data *pdc_irqd = irq_get_handler_data(d->irq);
>
> g = &pctrl->soc->groups[d->hwirq];
>
> raw_spin_lock_irqsave(&pctrl->lock, flags);
>
> + if (pdc_irqd)
> + irq_set_irq_type(pdc_irqd->irq, type);
> +
> /*
> * For hw without possibility of detecting both edges
> */
> @@ -779,9 +783,13 @@ static int msm_gpio_irq_set_wake(struct irq_data *d,
> unsigned int on)
> struct gpio_chip *gc = irq_data_get_irq_chip_data(d);
> struct msm_pinctrl *pctrl = gpiochip_get_data(gc);
> unsigned long flags;
> + struct irq_data *pdc_irqd = irq_get_handler_data(d->irq);
>
> raw_spin_lock_irqsave(&pctrl->lock, flags);
>
> + if (pdc_irqd)
> + irq_set_irq_wake(pdc_irqd->irq, on);
> +
> irq_set_irq_wake(pctrl->irq, on);
>
> raw_spin_unlock_irqrestore(&pctrl->lock, flags);
> @@ -863,6 +871,92 @@ static bool msm_gpio_needs_valid_mask(struct msm_pinctrl
> *pctrl)
> return device_property_read_u16_array(pctrl->dev, "gpios", NULL, 0) > 0;
> }
>
> +static irqreturn_t wake_irq_gpio_handler(int irq, void *data)
> +{
> + struct irq_data *irqd = data;
> + struct gpio_chip *gc = irq_data_get_irq_chip_data(irqd);
> + struct msm_pinctrl *pctrl = gpiochip_get_data(gc);
> + const struct msm_pingroup *g;
> + unsigned long flags;
> + u32 val;
> +
> + if (!irqd_is_level_type(irqd)) {
> + g = &pctrl->soc->groups[irqd->hwirq];
> + raw_spin_lock_irqsave(&pctrl->lock, flags);
> + val = BIT(g->intr_status_bit);
> + writel(val, pctrl->regs + g->intr_status_reg);
> + raw_spin_unlock_irqrestore(&pctrl->lock, flags);
> + }
> +
> + return IRQ_HANDLED;
> +}
> +
> +static int msm_gpio_pdc_pin_request(struct irq_data *d)
> +{
> + struct gpio_chip *gc = irq_data_get_irq_chip_data(d);
> + struct msm_pinctrl *pctrl = gpiochip_get_data(gc);
> + struct platform_device *pdev = to_platform_device(pctrl->dev);
> + const char *pin_name;
> + int irq;
> + int ret;
> +
> + pin_name = kasprintf(GFP_KERNEL, "gpio%lu", d->hwirq);
> + if (!pin_name)
> + return -ENOMEM;
> +
> + irq = platform_get_irq_byname(pdev, pin_name);
> + if (irq < 0) {
> + kfree(pin_name);
> + return 0;
Do I understand correctly that this is the case where the pin isn't
routed to the PDC?
> + }
> +
> + ret = request_irq(irq, wake_irq_gpio_handler, irqd_get_trigger_type(d),
> + pin_name, d);
> + if (ret) {
> + pr_warn("GPIO-%lu could not be set up as wakeup", d->hwirq);
'\n' is missing
> + kfree(pin_name);
> + return ret;
> + }
> +
> + irq_set_handler_data(d->irq, irq_get_irq_data(irq));
> + disable_irq(irq);
> +
> + return 0;
> +}
> +
> +static int msm_gpio_pdc_pin_release(struct irq_data *d)
> +{
> + struct irq_data *pdc_irqd = irq_get_handler_data(d->irq);
> +
> + if (pdc_irqd) {
> + irq_set_handler_data(d->irq, NULL);
> + free_irq(pdc_irqd->irq, d);
You need to free 'pin_name' allocated in msm_gpio_pdc_pin_request().
IIUC it should be available in irq_desc->action->name.
Cheers
Matthias
