On Tue, Sep 04, 2018 at 11:44:20AM -0400, Jeff Layton wrote: > On Tue, 2018-09-04 at 22:56 +0800, 焦晓冬 wrote: > > On Tue, Sep 4, 2018 at 7:09 PM Jeff Layton <jlay...@redhat.com> wrote: > > > > > > On Tue, 2018-09-04 at 16:58 +0800, Trol wrote: > > > > That is certainly not possible to be done. But at least, shall we report > > > > error on read()? Silently returning wrong data may cause further damage, > > > > such as removing wrong files since it was marked as garbage in the old > > > > file. > > > > > > > > > > Is the data wrong though? You tried to write and then that failed. > > > Eventually we want to be able to get at the data that's actually in the > > > file -- what is that point? > > > > The point is silently data corruption is dangerous. I would prefer getting > > an > > error back to receive wrong data. > > > > Well, _you_ might like that, but there are whole piles of applications > that may fall over completely in this situation. Legacy usage matters > here.
Can I make a suggestion here? First imagine a spherical cow in a vacuum..... What I mean is: In the absence of boundary conditions (the real world) what would ideally happen? I'd say: * When you've written data to a file, you would want to read that written data back. Even in the presence of errors on the backing media. But already this is controversial: I've seen time-and-time again that people with raid-5 setups continue to work untill the second drive fails: They ignored the signals the system was giving: "Please replace a drive". So when a mail queuer puts mail the mailq files and the mail processor can get them out of there intact, nobody is going to notice. (I know mail queuers should call fsync and report errors when that fails, but there are bound to be applications where calling fsync is not appropriate (*)) So maybe when the write fails, the reads on that file should fail? Then it means the data required to keep in memory is much reduced: you only have to keep the metadata. In both cases, semantics change when a reboot happens before the read. Should we care? If we can't fix it when a reboot has happened, does it make sense to do something different when a reboot has NOT happened? Roger. (*) I have 800Gb of data I need to give to a client. The truck-of-tapes solution of today is a 1Tb USB-3 drive. Writing that data onto the drive runs at 30Mb/sec (USB2 speed: USB3 didn't work for some reason) for 5-10 seconds and then slows down to 200k/sec for minutes at a time. One of the reasons might be that fuse-ntfs is calling fsync on the MFT and directory files to keep stuff consistent just in case things crash. Well... In this case this means that copying the data took 3 full days instead of 3 hours. Too much calling fsync is not good either. -- ** r.e.wo...@bitwizard.nl ** http://www.BitWizard.nl/ ** +31-15-2600998 ** ** Delftechpark 26 2628 XH Delft, The Netherlands. KVK: 27239233 ** *-- BitWizard writes Linux device drivers for any device you may have! --* The plan was simple, like my brother-in-law Phil. But unlike Phil, this plan just might work.