The joystick (B3) on stm32746g-eval uses gpios on STMFX gpio expander.
These gpios need a pin configuration (push-pull and bias-pull-up),
described under stmfx_pinctrl node.
Signed-off-by: Amelie Delaunay <amelie.delau...@st.com>
Acked-by: Linus Walleij <linus.wall...@linaro.org>
---
arch/arm/boot/dts/stm32746g-eval.dts | 43 ++++++++++++++++++++++++++++++++++++
1 file changed, 43 insertions(+)
diff --git a/arch/arm/boot/dts/stm32746g-eval.dts
b/arch/arm/boot/dts/stm32746g-eval.dts
index 203faf0..b86ad83 100644
--- a/arch/arm/boot/dts/stm32746g-eval.dts
+++ b/arch/arm/boot/dts/stm32746g-eval.dts
@@ -86,6 +86,43 @@
};
};
+ joystick {
+ compatible = "gpio-keys";
+ #size-cells = <0>;
+ pinctrl-0 = <&joystick_pins>;
+ pinctrl-names = "default";
+ button-0 {
+ label = "JoySel";
+ linux,code = <KEY_ENTER>;
+ interrupt-parent = <&stmfx_pinctrl>;
+ interrupts = <0 IRQ_TYPE_EDGE_FALLING>;
+ };
+ button-1 {
+ label = "JoyDown";
+ linux,code = <KEY_DOWN>;
+ interrupt-parent = <&stmfx_pinctrl>;
+ interrupts = <1 IRQ_TYPE_EDGE_FALLING>;
+ };
+ button-2 {
+ label = "JoyLeft";
+ linux,code = <KEY_LEFT>;
+ interrupt-parent = <&stmfx_pinctrl>;
+ interrupts = <2 IRQ_TYPE_EDGE_FALLING>;
+ };
+ button-3 {
+ label = "JoyRight";
+ linux,code = <KEY_RIGHT>;
+ interrupt-parent = <&stmfx_pinctrl>;
+ interrupts = <3 IRQ_TYPE_EDGE_FALLING>;
+ };
+ button-4 {
+ label = "JoyUp";
+ linux,code = <KEY_UP>;
+ interrupt-parent = <&stmfx_pinctrl>;
+ interrupts = <4 IRQ_TYPE_EDGE_FALLING>;
+ };
+ };
+
usbotg_hs_phy: usb-phy {
#phy-cells = <0>;
compatible = "usb-nop-xceiv";
@@ -129,6 +166,12 @@
interrupt-controller;
#interrupt-cells = <2>;
gpio-ranges = <&stmfx_pinctrl 0 0 24>;
+
+ joystick_pins: joystick {
+ pins = "gpio0", "gpio1", "gpio2", "gpio3",
"gpio4";
+ drive-push-pull;
+ bias-pull-up;
+ };
};
};
};
--
2.7.4
