On 10/5/2018 10:54 AM, Timur Tabi wrote:
On 10/05/2018 11:17 AM, Jeffrey Hugo wrote:>
Looks like the driver is initing just fine to me. Is setting up the
jumpers and running gpio-test warranted?
Well, that test only makes sure that input/output is actually working
on the hardware level, but it also makes sure that the GPIOs are
numbered correctly.
If you want, just put a printk(... offset) in msm_gpio_get() and read
from a GPIO that you know you have access to, and make sure the
'offset' is correct.
Then try reading from a GPIO that you don't have access to, and make
sure you get a failure before msm_gpio_get() is called.
Done.
For the series:
Tested-by: Jeffrey Hugo <jh...@codeaurora.org>
--
Jeffrey Hugo
Qualcomm Datacenter Technologies as an affiliate of Qualcomm
Technologies, Inc.
Qualcomm Technologies, Inc. is a member of the
Code Aurora Forum, a Linux Foundation Collaborative Project.
